SANUS VLFS820-B2 90 Inch Full Motion Wall Mounts Instruction Manual

: August 28, 2024
: SANUS

Table of Contents

VLFS820-B2 90 Inch Full Motion Wall Mounts
- VLFS820-B2
WE’RE HERE TO HELP
- IMPORTANT SAFETY INSTRUCTIONS
Dimensions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

VLFS820-B2 90 Inch Full Motion Wall Mounts

VLFS820-B2

INSTRUCTION MANUAL
WE’RE

Dimensions

BEFORE YOU BEGIN

Supplied Parts and Hardware

WARNING: This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts!

NOTE: Not all hardware included will be used.

STEP 1 Attach TV Brackets to TV

1.3 Attach TV Brackets to Your TV

CAUTION: Avoid potential personal injuries and property damage! DO NOT use power tools for this step. Tighten the screws 06 only enough to secure the TV brackets to the TV.

STEP 2A Attach Wall Plate

Wood Stud Installation

Drywall covering the wall must not exceed 5/8 in. (16 mm)
Minimum wood stud size: nominal 2 x 4 in. (51 x 102 mm) actual 1½ x 3½ in. (38 x 89 mm)
Minimum spacing between studs: 16 in. (406mm)
Stud center must be verified

I MPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 2 Ÿ¡¢ in. (7 cm), using a 7/32 in. (5.5 mm) diameter drill bit.

CAUTION: Avoid potential personal injury or property damage!
Improper use could reduce the holding power of the lag bolt 09 .
Tighten the lag bolts 09 and lag washers 10 only until they are pulled FIRMLY against the wall plate 08 .
DO NOT over-tighten the lag bolts 09 . Go to STEP 3 on PAGE 8.

STEP 2B Attach Wall Plate

Solid Concrete or Concrete Block Installation

CAUTION: Avoid potential personal injury or property damage!

● Mount wall plate 08 directly onto concrete surface (no wall covering)
● Minimum solid concrete thickness: 8 in. (203 mm)
● Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm)
● Minimum spacing between lag bolts is 16 in.
● For concrete applications, arm assembly 11 (STEP 3) must remain centered in wall plate 08 .
Keep this in mind when selecting wall plate location

Concrete Anchors are not included
Contact Customer Service:
US: 1-800-359-5520
EMEA: +31 (0) 495 580 852
UK: +44 (0) 800 056 285
to inquire about the concrete anchors.

CAUTION: Be sure the anchors C1 are seated flush with the
concrete surface.

Concrete achors (Fischer UX10 x 60R) C1 available through Customer Service.

CAUTION: Avoid potential personal injury or property damage!
Improper use could reduce the holding power of the lag bolt 09 .
Tighten the lag bolts 09 and lag washers 10 only until they are pulled FIRMLY against the wall plate 08 .
DO NOT over-tighten the lag bolts 09 .

STEP 3 Hang TV onto Wall Plate

3.1 Attach Arm Assembly to Wall Plate
HEAVY! You may need assistance with this step.

3.2 Attach TV to Arm Assembly
HEAVY! You may need assistance with this step.

Manage Cables

1. IMP 1 ORTANT: Fully extend arm assembly 11 to ensure enough slack in cables.
2. Route your cables through the arm assembly 11 as shown.

TV Adjustments

TILT ADJUSTMENT
Your TV should adjust easily when moved, then
stay in place. If your TV is too loose or too tight use
the hex key 15 for additional tightening of the
right and left tilt tension screws T .

LEVEL ADJUSTMENT

LATERAL SHIFT
HEAVY! You may need assistance with this step.

CAUTION: Avoid potential injuries or property damage!
Do NOT adjust the arm position from center for concrete
applications. Arm 11 MUST remain centered in wall plate
08 for all concrete applications

1. Remove your TV (PAGE 9).
2. Open the cover plates, remove two screws 12 , and loosen screws at bottom of arm S to release arm assembly 11 .
3. Reposition the arm assembly 11 on the wall plate (STEP 3.1).
4. Reattach the two screws 12 (STEP 3.1), tigthen the screws at the bottom of arm S , and close the cover plates.
5. Hang your TV onto the arm assembly 11 following STEP 3.2.

Thank you for choosing Sanus! Please take a moment to let us know how we did:

Legrand AV Inc.
6436 City West Parkway
Eden Prairie, MN 55344 USA
US: +1 800-359-5520
SANUS.com

Legrand AV Netherlands B.V.
Franklinstraat 14 6003 DK Weert Netherlands
EMEA: +31 (0) 495 580 852
UK: +44 (0) 800 056 2853
SANUS.com

Authorized Representative for the UK
Starline Holding Technology Ltd.
Unit C Island Road
Reading RG2 0RP UK

Legrand AV Inc. and its aÀiliated corporations and subsidiaries (collectively, “Legrand”), intend to make this manual accurate and complete. However, Legrand makes no claim that the information contained herein covers all
details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice
or obligation of any kind. Legrand makes no representation of warranty, expressed or implied, regarding the information contained herein. Legrand assumes no responsibility for accuracy, completeness or suÀiciency of the
information contained in this document.
©2022 Legrand AV Inc. All rights reserved. SANUS is a brand of Legrand. SANUS, HeightFinder and the SANUS logo are trademarks of Legrand.
Thank you for choosing Sanus! Please take a moment to let us know how we did:
Authorized Representative for the UK
Starline Holding Technology Ltd.
Unit C Island Road
Reading RG2 0RP UK
Legrand AV Netherlands B.V.
Franklinstraat 14 6003 DK Weert Netherlands
EMEA: +31 (0) 495 580 852
UK: +44 (0) 800 056 2853
SANUS.com
Legrand AV Inc.
6436 City West Parkway
Eden Prairie, MN 55344 USA
US: +1 800-359-5520
SANUS.com
Legrand AV Inc. • 6436 City West Parkway • Eden Prairie, MN 55344 USA