Park Lane P Trap Two Pieces Toilet Installation Guide

Park Lane P Trap Two Pieces Toilet

Installation instruction for Dual Flush Valve

Installation Instruction Dual Flush Valve Mechanism

1. Hold the base of the flush valve and rotate the body counterclockwise take it out of the base.
2. Remove the hex nut and nut collar from flush valve base. Don’t remove the seal !
3. Insert the flush valve’s base into the water tank.Screw on the nut collar and hex nut properly.
4. Take the body of flush valve and set it into the base and lock in place by rotating it clockwise. Then Insert the tank to the bowl rubber gasket on to the flush valve’s outlet bottom.
5. Fasten the tank to bowl with one pair of plastic or stainless steel bolts. Make sure bolts have the black rubber washer under the bolt’s head.
6. To adjust the height of the overflow pipe, slide the lock (a), then set the desired height of the overflow pipe (b). Put the lock back after.

Inlet valve install

Flush button installation

Button installation for top ceramic hole

1. Unscrew the nut.
2. Insert the button into the hole on the water tank.Screw the nut.
3. Push in the spring lock (a) which is on the control box and then insert button (b) into the control box.

Basin waste installation instruction

1. Fixed the flim first and put in the hole
2. Fixed another flim at the bottom
3. Tighten the screw and finished

PAN-TO-FLOOR FIXING KIT INSTALLATION GUIDE

Please read these instructions carefully prior to starting the installation
Check the component list to parts to ensure you have a complete set. Retain this instruction for future requirements.

1. The toilet and cistern should be installed on a flat clean floor.
2. Once the correct position for the suite has been decided, mark the floor fixing holes, remove suite and drill floor where marked.
3. As shown in figure above insert rawlplug (2) into hole in the floor, put the fixing bracket (3) and the metal washer (4) over the hole and tighten using the screw (5).
4. Place the suite over the fixing bracket and line up with the pan anchor holes, insert screw guide (6) into anchor holes, using pan fixing screw (7) insert into screw guide (6) and tighten onto fixing bracket (3). Do not over tighten as this could cause damage to the pan.
5. Place chrome or white screw cap (8) onto pan fixing screw (7), press firmly.
6. After installation, please check the suite is firmly in place.

Installing the toilet seat

Installation for water pipe (horizontal)

Installing the Toilet Base

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>