MAXIM LIGHTING 86435 Calibro 20 Outdoor Wall Sconce Instruction Manual

Table of Contents

For outdoor use, caulk around the fixture with silicone sealant to prevent water intrusion.
Leave a gap at the bottom to allow moisture to escape.
This product is compatible with the following dimmers:

Important Notes

This product must be installed by an experienced professional with critical knowledge of electronic lighting systems.

Q: Can this outdoor wall sconce be used indoors?
A: It is recommended for outdoor use but can be used indoors as well if desired.
Q: What is the warranty period for this product?
A: Please refer to the warranty information provided with the product or contact customer support for details on the warranty period.

Item/Model Number: 86435

LED LOW-VOLTAGE AND OUTDOOR INSTRUCTIONS

Read the instructions carefully before assembling the product.
When you open the package with a sharp tool like a box knife, be careful not to damage the components inside.
Carefully remove all packaging materials and retain them for future use.
Keep all hardware parts and packaging out of reach of children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
Ensure that you have all the required contents for complete assembly.
Take care when lifting. Assemble the product near where you intend to install it.
Do not over-tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.

Risk of suffocation!
Keep packaging materials away from children.

Lamp Care Instructions

Carefully read through the instruction sheet before assembly and using the product.
Caution there is a risk of shock!
Disconnect from the power source before assembling or cleaning.
Switch off, unplug, and allow the bulb to cool before replacing the bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it could cause fire. Check the product cord to be sure is free torn or frayed.
WARNING: Wires must be connected to a low-voltage driver and should not be connected directly to live wire or a short may occur.
WET LOCATION: For outdoor use, caulk around the fixture with silicone sealant to prevent water intrusion.

On polished finishes, often using talc powder can reduce the appearance of fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass cleaner, stone polish, & wood polish.
Clean with a soft cloth and a mild detergent. Do not use abrasive or harsh cleaners.
Periodically (every 90-180 days) make sure that the screws are fully tightened.
Prolonged exposure to heat sources may cause glazing, melting, and scorching, or even cause color to fade.

This fixture is equipped with an LED driver, please refer to the Wiring Diagram for more details
For outdoor use, caulk around the fixture with silicone sealant to prevent water intrusion. Leave a gap at the bottom to allow moisture to escape.

MUST be installed by an experienced professional CRITICAL KNOWLEDGE of electronic lighting systems required

ITEM/MODEL: 86435

IMPROPER WIRING and/or INCORRECT DIMMER use can cause CATASTROPHIC DAMAGE!
THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH DO NOT CUT FACTORY-MADE CONNECTIONS.

LED DRIVER DIAGRAM

VERIFIED LIST OF TESTED DIMMERS

GENERAL COMPATIBILITY

IMPORTANT!

If the control is not paired properly with LED fixtures, irreparable damage may occur.
If the dimmer you are using is not listed here, consult a lighting professional or view our Dimming Compatibility Chart online: https://www.maximlighting.com/led-dimmer

MUST be installed by an experienced professional CRITICAL KNOWLEDGE of electronic lighting systems required