n-com SPCOM00000052 Connector Cover Cap User Manual
- June 3, 2024
- N-Com
Table of Contents
SPCOM00000052 Connector Cover Cap
User Manual
INSTRUCTIONS FOR REPLACING THE SPCOM00000052
- Remove the N-Com system from the helmet (see instruction booklet).
- Remove the screws using a Torx T6 screwdriver and move the antenna from its housing (Fig. 1).
- Cut and remove the connector cover cap that needs to be replaced (Fig. 2).
- Position the new connector cover cap in its housing (Fig. 3).
- Reposition the antenna, matching up the two holes where the screws pass through. Replace the screws and tighten them (Fig. 4).
- Reposition the N-Com system inside the helmet (see instruction booklet).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>