MAXIM LIGHTING 86433 Calibro 15 LED Outdoor Sconce Installation Guide
- August 16, 2024
- MAXIM LIGHTING
Table of Contents
86433Item/Model Number:
Calibro 15″ LED Outdoor Sconce
Lamping | Ampoule:2xLED 7W(Included)
Please consult a qualified electrician prior to install
Made in China
LED LOW-VOLTAGE AND OUTDOOR INSTRUCTIONS
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a box knife, be careful not
to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of children.
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to install it.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
Risk of suffocation!
- Keep packaging materials away from children.
Lamp Care Instructions
Carefully read through the instruction sheet before assembly and using the product.
Caution there is a risk of shock!
Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Check the product cord to be sure is free torn or frayed.
WARNING : Wires must to be connected to low voltage driver and should not
be connected directly to live wire or a short may occur.
WET LOCATION: For outdoor use, caulk around fixture with silicone sealant
to prevent water intrusion.
Cleaning & Maintenance
On polished finishes, often using talc powder can reduce the appearance of
fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, stone polish, & wood polish.
Clean with soft cloth and a mild detergent. Do not use abrasive or harsh
cleaners.
Periodically (every 90-180 days) make sure that the screws are fully
tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
PARTS
Before getting started, ensure the package ‘contains the following components:
“This fixture is equipped with an LED driver, please refer 1o the Wiring Diagram for more details
For outdoor use, caulk around future with silicone sealant to prevent water intrusion. Leave a gap at the bottom to allow moisture 1o escape.
WIRING DIAGRAM
DIMMER COMPATIBILITY
MUST be installed by an experienced professional
CRITICAL KNOWLEDGE of electronic lighting systems required
IMPROPER WIRING and/or INCORRECT DIMMER use can cause CATASTROPHIC DAMAGE!
‘THIS FIXTURE MUST BE INSTALLED with a COMPATIBLE DIMMER SWITCH
DO NOT CUT FACTORY-MADE CONNECTIONS.
SCHEMATIC
FOR GENERAL
REFERENGE ONLY
VERIFIED LIST OF TESTED DIMMERS
Lutron Diva DVCL-153P Lutron Diva DVELV-300P
Lutron Skylark CTCL-153p
DEAKO-Smart Dimmer
DEAKO-Simple Dimmer LEVITON 68721
LEVITON 6674
LEVITON DSLO6
GENERAL COMPATIBILITY
TRIAC / FORWARD PHASE
ELV / REVERSE PHASE
ONLY at 120VAC
Due to inrush current, wattage should not exceed 150W on 2 600W dimmer
IMPORTANT!
If the control is not paired properly to LED fixtures, irreparable damage may
occur.
If the dimmer you are using is not lilted here, consult lighting professional
or view our Dimming Compatiblity Chart online:
https://www.maximlighting.com/led-dimmer
MUST beinstalled by an experienced professional
CRITICAL KNOWLEDGE of electronic lighting systems required
© 2024 MAXIN LIGHTING