ZKTECO VT07-B01 Video Door Phone Installation Guide
- August 15, 2024
- ZKTECO
Table of Contents
ZKTECO VT07-B01 Video Door Phone
Specifications:
- Model: VT07-B01
- Version: 1.0
- Dimensions:
- 7 LCD Touch Screen: 4.61 inches (117.0mm)
- Device Size: 7.28 inches (185.0mm) x 0.90 inches (22.8mm)
- Installation Environment: Indoor use only, avoid installation near glass windows, direct sunlight, and heat sources.
- Connection: Ethernet connection required
Product Usage Instructions
Device Installation:
Mode 1: Install on the wall
- Find a suitable indoor location at a height of 59.1 inches (1.5m).
- Attach mounting template stickers to the wall and drill holes.
- Fix the back plate on the wall using mounting screws.
- Push the device onto the back plate and secure it.
Mode 2: Install on the desktop
- Remove the device and bracket from the box.
- Place the white bracket rubber sleeve on the bracket bottom.
- Insert the bracket into the mounting slot behind the device.
Ethernet Settings:
- Click Setting > Advanced Setting > Network Manage to enter the Wired Network Configuration Setting.
- Set IP Type to Static and configure IP Address, Subnet Mask, DNS, and Gateway accordingly.
Video Door Phone Connection:
To activate the video intercom function, configure the indoor station with the
network and tap the icon on the Video Intercom screen. Enter the IP address of
the indoor station in the designated interface.
FAQs:
Q: What should I do if I encounter network connection issues?
A: Check the Ethernet settings and ensure that the IP addresses of all
connected devices are in the same network segment.
Q: Can I install the device outdoors?
A: No, the device is designed for indoor use only. Avoid installation
near glass windows, direct sunlight, or heat sources.
Due to regular upgrades of systems and products, ZKTeco could not guarantee exact consistency between the actual product and the written information in this manual.
Dimensions
VT07-B01
Installation Environment
Device Installation
Mode 1: Install on the wall
- Find a suitable indoor installation location, the recommended installation height is 59.1 inches (1.5m), which can be adjusted as needed.
- Attach the mounting template stickers to the wall and drill holes, then fix the back plate on the wall with the wall mounting screws.
- Finally, push the device into the back plate and secure it to the back plate.
Mode 2: Install on the desktop
- Take out the device and the bracket from the box.
- Put the white bracket rubber sleeve on the bottom of the bracket.
- Finally, insert the bracket into the mounting slot behind the device.
Connection Diagram
NOTE
- VT07-B01, VTO and IP Camera are connected through out the network cable.
- In LAN, the IP addresses of all devices must be in the same network segment.
Ethernet Settings
Click Setting > Advanced Setting > Network Manage to enter the Wired Network Configuration Setting interface to set the network parameters.
Video Door Phone Connection
On the Video Intercom
Once the indoor station is configured with the network, the video intercom function can be activated by tapping the icon on the Video Intercom screen. Enter the IP address of the indoor station in the jumping interface.
On the VT07-B01
After receiving the caller tone, you can perform the following operations.
ZKTeco Industrial Park, No. 32, Industrial Road, Tangxia Town, Dongguan, China.
Phone: +86 769 – 82109991
Fax: +86 755 – 89602394
Copyright © 2024 ZKTECO CO., LTD. All Rights Reserved.