MAXIM LIGHTING 86421 Culvert 7.5 Inch LED Outdoor Sconce Instruction Manual
- August 15, 2024
- MAXIM LIGHTING
Table of Contents
MAXIM LIGHTING 86421 Culvert 7.5 Inch LED Outdoor Sconce
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a box knife, be careful not
to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of children.
Choose aclean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you
intend to install it.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
Risk of suffocation!
Keep packaging materials away from children.
Lamp Care Instruction
Carefully read through the instruction sheet before assembly and using the product.
Caution thereisa riskof shock!
Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it
could cause fire.
Check the product cord to be sure is free torn or frayed.
WARNING : Wires must to be connected to low voltage driver and should not
be connected directly to live wire or a short may occur.
WET LOCATION : For outdoor use, caulk around fixture with silicone
sealant to prevent water intrusion.
Cleaning and Maintenance
On polished finishes, often using talc powder can reduce the appearance of fingerprints and other smudges.
For respective shade surfaces, use the appropriate cleansers, i.e. glass
cleaner, stone polish, & wood polish.
Clean with soft cloth and a mild detergent. Do not use abrasive or harsh
cleaners.
Periodically (every 90-180 days) make sure that the screws are fully
tightened.
Prolonged exposure to heat sources may cause glazing, melting and scorching,
or even cause color to fade.
PARTS
This fixture is equipped with an LED driver, please refer to the Wiring Diagram for more details
For outdoor use, caulk around fixture with silicone sealant to prevent water intrusion. Leave a gap at the bottom to allow moisture to escape.
WIRING DIAGRAM
VERIFIED LIST OF TESTED DIMMERS
- Lutron Diva DVCL-153P
- Lutron Diva DVELV-300P
- Lutron Skylark CTCL-153P
- DEAKO-Smart Dimmer
- DEAKO-Simple Dimmer
- LEVITON 6672-L
- LEVITON 6674
- LEVITON DSL06
GENERAL COMPATIBILITY
TRIAC / FORWARD PHASE
ELV / REVERSE PHASE
ONLY at 120VAC
Due to inrush current, wattage should not exceeed 150W on a 600W dimmer
IMPORTANT! If the control is not paired properly to LED fixtures,
irreparable damage may occur.
If the dimmer you are using is not listed here, consult a lighting
professional or view our Dimming Compatibility Chart online:
https://www.maximlighting.com/led-dimmer