TGK MOTORSPORT TGK-ACC-07 Block Billet Jack Installation Guide
- August 15, 2024
- TGK MOTORSPORT
Table of Contents
TGK MOTORSPORT TGK-ACC-07 Block Billet Jack
INSTALLATION INSTRUCTIONS
STEP 1
FOR BOTH FRONT BLOCK INSTALLATIONS YOU NEED TO USE TGK-ACC-07-002
THREAD ONE OF THE PROVIDED RODS INTO ACC-07-002
STEP2
FISH TGK-ACC-07-002 INTO HOLE AND ROTATE TO LOCATE SECOND HOLE
THREAD THE SECOND OF THE PROVIDED RODS INTO ACC-07-002
STEP3
PUSH UP THE JACK BLOCK ONTO THE LOCATING RODS SO IT IS FLUSH TO FRAME
STEP4
WHILE MAINTAINING PRESSURE DOWNWARD WITH ONE ROD, PUSH THE BLOCK UP AT THE
SAME TIME.
REMOVE ONE OF THE RODS
-UNTIL SECOND BOLT IS THREl&Dl=D, BE MINDFUL OF THE BACKPLATE ROTATING-
STEP 3
WHILE MAINTAINING PRESSURE ON THE BACK PLATE, THPE/10 IN ONE OF THE
PROVIDED BOLTS.
TIGHTEN BOLT WITH ALLEN KEY
STEP 4
CAREFULLY THPE/10 IN SECOND BOLT AND TIGHTEN WITH ALLEN KEY.
STEP 5
FOR THE REAR INSTAC C, THPFA!J THE PROVIDED LOCATING RODS INTO BOTH
TGK-ACC-O7-OO3
STEP 6
INSERT BOTH ACC-O7-OO3 INTO ACC-O7-OO4
*DISCLAIMER”
ACC-O7-OO1-A WAS AN ALPHA PART
USED FOR PHOTO
STEP 7
ORIENT THE FEET TO SLIDE THEM INTO FRAME HOLES.
THE FEET ARE KEYED SO THEY ARE MEANT TO BE ROTATED AFTER THE BLOCK IS UP TO
THEFRAMP
BELOW IS THE FINAL ORIENTATION OF THE FEET ONCE TIGHTENED
STEP 8
REMOVE ONE ROD WHILE MAINTAINING PRESSURE OF THE ALTERNATE FOOT TO THE BACK OF
THE VEHICLE FRAME.
REPLACE ROD WITH BOLT AND SECURE WITH ALLEN KEY
STEP 9
REMOVE SECOND ROD AND CAREFULLY REPLACE WITH BOLT.
THE FOOT CAN BE PUSHED UP WITHOUT THE ROD INSTALLED. LET THE THREADS PULL THE
BOLT AND FOOT TOGETHER”
TIGHTEN BOLT WITH ALLEN KEY
STEP 10
ENJOY EFFORTLESS JACKING
YOUR INBTAI.LATION IS COMPLETE!
VISIT
WWW.TGKMOTORSPORT.COM FOR MORE PRODUCTS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>