VOLLRATH 38735N Cafeteria Breath Guard Installation Guide
- August 13, 2024
- VOLLRATH
Table of Contents
VOLLRATH 38735N Cafeteria Breath Guard
Specifications
- Product Name: Cafeteria Breath Guard
- Variants: One Piece, Three Piece
- Manufacturer: Vollrath Company, L.L.C.
- Item No.: 2350030-01
FAQs
- Q: What should I do if I over-tighten the cap nuts during installation?
- A: If you over-tighten the cap nuts, it may cause the plastic to crack. It is recommended to use caution and avoid overtightening to prevent damage.
Installation Instructions
One Piece Cafeteria Breath Guard Three Piece Cafeteria Breath Guard
These instructions cover the installation of the one-piece Cafeteria Breath Guard and the three-piece Cafeteria Breath Guard.
METHOD 1: One Piece Breath Guard Installation
Some units are shipped with a breath guard not installed.
To install the breath guard follow these steps:
NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
- Install the side breath protector (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
METHOD 2: Three-Piece Breath Guard Installation
Some units are shipped with a breath guard not installed.
To install the breath guard follow these steps:
NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
- Install the side shield (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
- Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
- Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.
CONTACT INFORMATION
- The Vollrath Company, L.L.C. 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A.
- Main Tel: 800.628.0830
- Service Tel: 800.628.0832
- FAX: 800.752.5620 Vollrath of Canada, Co.
- Tel: 800.695.8560
- FAX: 800.752.5620
- © 2010 The Vollrath Company, L.L.C.
- Item No. 2350030-01
- Rev 04/12
- www.vollrathco.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>