VOLLRATH 39728A Cafeteria Breath Guard Installation Guide
- August 14, 2024
- VOLLRATH
Table of Contents
VOLLRATH 39728A Cafeteria Breath Guard
Specifications:
- Product Name : Cafeteria Breath Guard
- Model : One Piece and Three Piece
- Manufacturer : Vollrath Company, L.L.C.
- Item No.: 2350030-01
Product Usage Instructions
These instructions cover the installation of the one pice Cafeteria Breath Guard and the three-piece Cafeteria Breath Guard.
One Piece Breath Guard Installation:
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
- Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
Three-Piece Breath Guard Installation:
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
- Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
- Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations
The Vollrath Company, L.L.C.
- 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A.
- Main Tel: 800.628.0830
- Service Tel: 800.628.0832
- FAX : 800.752.5620
Vollrath of Canada, Co.
- Tel: 800.695.8560
- FAX: 800.752.5620
© 2010 The Vollrath Company, L.L.C.
Frequently Asked Questions
Q: What should I do if I accidentally overtighten the cap nuts?
A: If you accidentally overtighten the cap nuts, stop immediately to prevent
plastic cracking. Loosen the cap nuts slightly and then re-tighten them with
caution.
Q: Can I adjust the height of the breath guards?
A: The height of the breath guards can be adjusted during installation by
positioning the components accordingly on the studs and support tubes.