SmartLife K02-DC Smart Chime Owner’s Manual
- August 13, 2024
- SmartLife
Table of Contents
SmartLife K02-DC Smart Chime
Product Usage Instructions
Operation Instruction
- Connect the Smart Chime to the power supply.
- Long press the button for 10 seconds until you hear the prompt tone to enter the WiFi pairing mode.
- Open the APP, go to Settings, select Indoor doorbell, then pair and wait for the Smart Lock to connect to Chime WiFi.
- If the WiFi connection is successful, the APP will prompt Smart Chime to connect successfully.
Setting Procedure
- Connect the Smart Chime to the power supply.
- Long press the button for 10 seconds, and you will hear the prompt tone, then enter the WiFi pairing mode.
- Open the APP, enter Settings, select Indoor doorbell– pair– Next, and wait for the Smart Lock to connect to Chime WiFi.
- If the WiFi connection is successful, the APP will prompt Smart Chime to connect successfully.
Product picture
Product parameter
Parameter/Instructions
- Model K02-DC
- Color white/black
- Dimension 49.849.833mm
- Input AC100~240V
- WiFi 2.4G
Operation instruction
Setting procedure
- Connect the Smart Chime to the power supply, long press the button for 10 seconds, you will hear the prompt tone, then enter the WiFi pairing mode.
- Open the APP, enter Settings, select Indoor doorbell– pair– Next, and wait for the Smart Lock to connect to Chime WiFi.
- If the WiFi connection is successful, the APP will prompt Smart Chime to connect successfully
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, according to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance 20cm between the radiator & your body.
FAQ
- Q: What should I do if the Smart Chime does not connect to WiFi?
- A: If the connection fails, try restarting the Smart Chime and your WiFi router. Make sure you are within range of your WiFi signal.
- Q: How do I reset the Smart Chime?
- A: To reset the Smart Chime, press and hold the reset button for 15 seconds until you hear a confirmation tone.
- Q: Can I use the Smart Chime with multiple devices?
- A: Yes, you can pair the Smart Chime with multiple devices by following the pairing instructions in the user manual for each device.