PawHut D04 Series Pet Bed Installation Guide
- August 11, 2024
- PawHut
Table of Contents
PawHut D04 Series Pet Bed
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
- To keep the bed and cover flat, please adjust the fabric with some force to move into the right position when assembling.
- For step 5-6, please align metal pipes with plastic parts first, then insert the pipes into the plastic parts.
- For step 5, the velcro may not be completely covered. As the cover being used for a period of time, will be a little looser than before, then you could tighten the cover the velcro completely.
- When the cover has been used for a while, you will be able to tighten the velcro.
PARTS
Separate the velcro on the back of cover and insert the metal pipe A into the fabric as illustrated.
lnsert 2 bed legs B into metal pipe A.
Insert 2 metal pipes C into the bed legs B as illustrated.
Please repeat step 2 on the other side,then connect 2 bed legs B with 2 metal pipes C.
Pull hard over the metal pipe A, then stick the velcro. (see note 3)
Turn the pet bed over.
Parts G and H required
Insert 4 tent poles H to the plastic connectors through the holes on the canopy.
Canopy finished! (Note: To connect the canopy witht the pet bed cor rectly; thebigger angles of the canopy should be pointed to the long sides of the bed, the smaller angles of the canopy should be pointed to the short sides of the bed.)
Plug the tent pole ends to the corners of the bed.
Secure the canopy with the bungee cords at each corner of the bed legs B.
Finished!(Note: The canopy side with plastic connectors faces outwards)
If you have any questions, please contact our customer care center.
Our contact details are below
001-877-644-9366
customerservice@aosom.com
Imported by Aosom LLC
27150 SW Kinsman Rd Wilsonville, OR 97070 USA
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>