TsureIand TL-TS1820 Wireless Remote Turn Signal User Manual
- July 30, 2024
- TsureIand
Table of Contents
TsureIand TL-TS1820 Wireless Remote Turn Signal
Product Information
Specifications
- Compliance: Part 15 of FCC Rules
- Radiation Exposure Limits: FCC approved for uncontrolled environment
- Minimum Distance: 0cm between radiator and body
Product Usage Instructions
Installation
Ensure the device is placed in an area with proper ventilation and follow any specific installation guidelines provided in the user manual.
Operation
Power on the device using the designated power button. Follow the user interface to navigate through different functions and settings. Ensure the device is not causing harmful interference.
Maintenance
Regularly clean the device using a soft, dry cloth. Avoid using harsh chemicals that may damage the device’s exterior.
Safety Guidelines
Always maintain a minimum distance of 0cm between the radiator of the device and your body during operation to comply with FCC radiation exposure limits.
Function Description
Remote control: a total of 4 buttons, each button is equipped with an indicator.
Product Features
- Large visual range.
- Easy to install.
- Built in 900mAh rechargeable battery, long life
- The surface waterproof effect reaches ipx2 to ensure daily use.
- High quality led to ensuring the warning effect.
The operation method of the tail lamp
- When charging, please remove the tail lamp, open the protective cover of the rubber charging port on the back of the tail lamp, and plug in the micro plug for USB charging cable.
- The lamp and remote control are matched at the factory and can be used after installation.
- The tail lamp and controller are combined with the corresponding accessories, and then respectively installed in the appropriate position of the vehicle.
- When the battery is replaced after the match is forgotten because the battery is exhausted, long press the main light switch and remote control switch for 3 seconds at the same time.
Matters needing attention
- Don’t disassemble and refit without permission.
- This product is only rainproof, do not soak the product in water.
- After use, please turn off the tail light switch button to avoid battery power loss.
- Pay attention to the battery inside the tail lamp, and do not replace it yourself.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, maycause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0cm between the radiator and your body
FAQs
Q: What should I do if the device is causing interference?
A: If the device is causing interference, try relocating it to a different area. Ensure no other electronic devices are interfering with its operation.
Q: Can I make modifications to the device?
A: No, any changes or modifications not approved by the manufacturer may void your authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>