PBS NZ PBS Door Handle Passage Satin Nickel Installation Guide

July 30, 2024
PBS NZ

PBS NZ PBS Door Handle Passage Satin Nickel Installation Guide
PBS NZ PBS Door Handle Passage Satin Nickel

Instructions for Installation of Lever Set

Tools required for new installation:

  • 1 Phillips head screwdriver
  • 1 2 – ⅛” (54mm) hole saw
  • 1 1”(25.4mm) drill bit
  • 1 chisel

Tools required for replacement:

  • 1 Phillips head screwdriver

INSTALLATION

Installation

  1. Start approximately 36” (914mm) from floor. Fold and apply template to edge of door and mark centre of door edge as indicated on template.
    (NOTE: Backset on door face must be same as backset of lock.)
    Installation

  2. Drill 2 – ⅛” (54mm) hole through door face as marked for lockset. It is recommended that holes be drilled from both sides to prevent splitting.
    0Drill 1” (25.4mm) hole in centre of door edge for latch.
    Installation

  3. Insert latch in hole keeping it parallel to face of door. Mark outline and remove latch.
    Installation

  4. Chisel ⅛” (3mm) deep or until latch face is flush with door edge.
    Installation

  5. Insert latch and tighten screws.
    (NOTE: Latch bolt bevel must face to closing direction.)
    Installation

  6. Close door until latch bolt touches jamb to locate strike in jamb and centre line of strike. Open door and extend line from mark to door stop. Measure one half of door thickness from door stop and vertically mark drill point centre for strike.
    Installation

  7. Drill 1” (25.4mm) hole ½” (12.7mm) deep in door jamb on drill point for strike.

CAUTION: To ensure proper lockset function hole in jamb must be drilled a full ½” (12.7mm) deep.

  1. Cut out jamb ¹⁄₁₆” (1.5mm) deep for strike.
    Tighten screws.
    Installation
    Guard-bolt stops against strike, as illustrated, preventing forcing when door is closed. Adjustable tang on strike permits bending in or out to eliminate a too loose fit between door and door stop.

  2. Insert outside lever with spindle throughout the latch spindle hub.
    Installation

  3. Place outside lever against door, as illustrated.
    Installation

  4. Place inside unit in position onto spindle.
    Insert and tighten mounting screws.
    Installation

  5. Adjustable Backset 2 – ⅜” (60MM) or 2 – ¾” (70MM)

PBS NZ
W: www.pbsnz.co.nz
E: orders@pbsnz.co.nz 23 Carr Street, Tuakau, 2121

Company Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals