Nomadic Supply Premier Products RV10-P Egress Window Installation Guide
- July 29, 2024
- Nomadic Supply
Table of Contents
Nomadic Supply Premier Products RV10-P Egress Window Installation Guide
Step 1: Preparing the Truck
Remove the factory adhesive from the top ledge of the window cavity using a 90 degree sander.
Painted over to prevent rusting and to finish off what areas may still be visible when the window is opened. Use the black Rust-Oleum enamel paint and a small foam brush. Apply one even coat.
The Rust-Oleum paint requires 24 hours to dry
Step 2: Drilling the Mounting Holes
Place the pattern tight to the window cavity. With another individual holding the pattern steady in this position, drill through the bushings on the pattern with a 7/32” drill bit.
Use two people to property place this pattern.
Place the pattern tight to the window cavity. With another individual holding the pattern steady in this position, drill through the bushings on the pattern with a 7/32″ drill bit.
Step 3: Installing Egress Window
With one person on the interior of the vehicle, carefully lift the window into place. Place a #8 washer and 8mm nut on each of these bolts and completely tighten two them. Shut the window and test for appropriate fit. Fasten the remaining bolts and install the new weather stripping.
Check these two seams for proper spacing. Also, confirm that the window will open and close properly
Step 4: Water Test
With an individual on the interior of the vehicle to spot for leaks, spray water at the window from all directions. Check the seam on the interior where the weather stripping meets the valance.
Required Tools
Drill with 7/32” Drill Bi
Foam Paint Brush
Black Rust-Oleum Paint
Window Pattern
Five 8mm Nuts
Five #8 Washer
8mm Socket Wrench
Angle Sander
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>