LLURIA D-ME19,2 RGB IP67 LED Strip Instruction Manual
- July 26, 2024
- LLURIA
Table of Contents
**LED strip
Waterproof IP67
Digital Miranda Estanca 19,2W/m RGB
**
D-ME19,2 RGB IP67 LED Strip
High-quality flexible digital LED strip light.
Ideal for all types of installations, general lighting, accent lighting and
decorative lighting.
For indoor use.
| Reference | Color | Lumens/ m |
|---|---|---|
| D-ME14,4-RGB-3P | Rojo Red | 155 |
| Verde Green | 395 | |
| Azul Blue | 85 |
Control system
Technical data
| Power | 19,2W/m |
|---|---|
| Roll power 5m | 72W |
| IP | 67 |
| Voltage | 12V |
| LED type | 5050 |
| LEDs/m | 60 |
| LEDs/px | 3 |
| Px/m | 20 |
| Chip IC | UCS5603 |
| Signal | SPI |
| Pixel continuity | Yes |
| Pitch | 16,7mm |
| Beam angle | 120° |
| Min. cutting lenght | 50mm |
| Roll length | 5m |
| Life time | 50.000h |
| Ambient temperature | -25-60°C |
| Storage temperature | -40-80°C |
| Warranty years | 3 |
| Needs heatsink | Yes |
| Needs controller | Yes |
Dimensions
Circuit diagram
Respect the schematic that will be delivered with the position of each of elements and the resupply.
Assembly detail
- Do not bend the LED strip to adapt them to sharp radius or angle.
- Check that the direction of the arrows or the text “LLURIA” are in the right direction.
- Check the operation of the LED strip before placing it on the profile.
- The installation of the system must be done without the power being switched on.
- Avoid using the same ignition and wiring or to put LED strips near a 220V signal or devices that may cause interference (motors, fans, washing machines, etc.).
- Follow the order of the installation according to the schematic.
- Leave zones with registers to access amplifiers, sources and resupply.
- Avoid passing wires in front of the LEDs in the installation to avoid shadows.
- The section of the power wiring from the source to the different resupplies must have a minimum section of 1.5mm for lengths of 10m, 2.5mm for lengths of 20m and 4mm for lengths of 30m.
Life time
The life time of our LEDs is 50.000h at an ambient temperature of 23ºC and
provided with a heat dissipation system.
Off cycles are recommended to extend the life of the LEDs.
Warnings
- To ensure the life of the LED, it is request to place on a surface that dissipates the heat they generate.
- Caution when handling cables to avoid damage to the welds.
- The voltage surges can cause damage.
- If diffuser is used with the dissipating profile, there may be variations in the color temperature.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>