WALRUSAUDIO Fundamental Series Ambient Reverb Effects Pedal Owner’s Manual
- July 27, 2024
- WALRUSAUDIO
Table of Contents
Fundamental Series Ambient Reverb Effects Pedal
Fundamental Ambient provides three different atmospheric reverb algorithms to
explore beautifully vast and lush soundscapes with plenty of decay time for
pillowy soft pad-like decay.
9 volt DC, Center Negative • 100mA min**
The use of an isolated power supply is recommended for powering all Walrus Audio Pedals.
Daisy chain power supplies are not recommended.
Got questions or need a repair?**
Email help@walrusaudio.com to talk with a real
live human about your Walrus gear!
This product comes with a limited lifetime warranty.
Click Here for more info.
CONTROLS
Decay: Controls the amount of reverb decay time. Left is the minimum and
right is the maximum amount of time.
Tone: Shapes the overall tonality of the reverbOn Deep and Lush this
controls the cutoff of a synth-style lowpass filter. On Haze this controls the
width of a resonant bandpass filter, filtering both high and low end at the
right, and allowing more high and low to pass through at the left.
Mix: Controls the mix of the effect and the original clean signal. All
the way to the left outputs only the fully clean signal, and all the way to
the right outputs only the affected Reverb signal.
MODES
Deep: A dark ambient reverb with an added low octave, perfect for
creating murky, cavernous sustain or adding a touch of moody atmosphere.
Lush: A breathy, expansive reverb featuring ultra-long sustain. Perfect
for generating silky pads and immersive soundscapes with every note. Haze:
A textured, lo-fi reverb featuring distortion, sample rate reduction, and a
resonant bandpass tone control, great for vintage or experimental tones.
TRAILS mode
The Ambient comes with trails mode active by default, to disengage trails mode
hold down the bypass stomp switch when applying power to the pedal. Once the
LED flashes it indicates that trails mode is turned off. To re-engage trails
mode, repeat the process,
and wait for the LED to turn dark, indicating that trails mode is back on.
With trails mode active, your reverb decay will fade off naturally after
turning the pedal off. With trails mode inactive, the decay abruptly cuts off
when you turn off the pedal.
Find the full
Fundamental Series at walrusaudio.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>