Anice 2BEJ6-YK100 Remote Control Instructions
- July 26, 2024
- Anice
Table of Contents
Anice 2BEJ6-YK100 Remote Control
Product Information
Specifications
- FCC ID : 2BEJ6-YK100
- RF Exposure: General exposure requirement met
- Usage: Portable exposure condition without restriction
Product Usage Instructions
Remote control
Arming key
Press the Arming key, the alarm turn on the arming function.
Disarm key
Press the Disarm key, the alarm turn off the arming function.
Mode key
Press the Mode key to switch alarm mode.
SOS key
Press the SOS key, the alarm will sound for 30 seconds, press the Disarm key
to cancel the alarm.
Initial Setup
Before using the device, ensure that it is properly connected to the
receiver as per the user manual.
Powering On
To power on the device, locate the power button and press it. Wait for the
device to boot up.
Adjusting Settings
You can adjust various settings such as volume, brightness, etc., using the
control panel or remote control.
Using the Device
Once powered on and settings adjusted, you can now use the device for its
intended purpose.
FCC Statment
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction
- FCC ID : 2BEJ6-YK100
FAQ
Q: What should I do if I face connectivity issues?
A: If you experience connectivity problems, make sure the device is properly
connected to the receiver. You may also consult the dealer or a radio/TV
technician for assistance.
Q: Is there a restriction on where I can use the device?
A: The device can be used in portable exposure conditions without any
restrictions as it meets general RF exposure requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>