IKEA JETSTROM LED Ceiling Light Panel 100×40 cm Instruction Manual

July 26, 2024
Ikea

JETSTRÖM
Instruction Manual

JETSTROM LED Ceiling Light Panel 100×40 cm

IKEA JETSTROM LED Ceiling Light Panel 100x40 cm

Getting started

Connect your product to the mains or plug the power cable into the wall socket.
Before you can use your light source you’ll need to pair it with a steering device.

  1. Make sure that your light source is installed and the main power switch is turned on.
  2. Hold the steering device close to the light source you want to add (no more than 5 cm away).
  3. Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.

Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
With the remote control you can switch between 9 colours and white lights. With the IKEA smart hub and the IKEA Home smart app, you get a total of 20 colours and white lights.

If you have the TRÅDFRI gateway or DIRIGERA hub
Go to App Store or Google Play and download the IKEA Home smart app. The app will take you through the process of installing your product and other devices.

CAUTION:
DO NOT USE WITH STANDARD DIMMERS.
This light source will not operate properly when connected to a standard (incandescent) dimmer or dimming control. Only controllable by IKEA Smart lighting products.
How to factory reset your product If the product does not respond or if you want to un-pair the product from a steering device you might have to make a factory reset. The product is forced to factory reset by carefully inserting a paper clip end or similar in the small hole (marked RESET) and apply a slight pressure.

IMPORTANT!

  • The product is for indoor use only and can be used in temperatures ranging from 5 °C to 40 °C (41°F to 104°F).
  • Do not leave the product in direct sunlight or near any heat source, as it may overheat.
  • The declared radio range between the unit and the steering device is measured in open air.
  • Different building materials and placement of the units can affect the wireless connectivity range.

Care Instructions

Wipe clean with a damp cloth. Never use abrasive cleaners or chemical solvents as this can damage the product.

Save these instructions for future use.

Technical data:
Type: L2205, L2206 JETSTRÖM
Input: 220-240 VAC, 9.5W
Max lumen output: 1150 lm
Radio range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power: Max 8.5 dBm

Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN

RF EXPOSURE INFORMATION

According to RF exposure regulations, under normal operations the end user shall refrain from being closer than 20 cm from the device.
This device complies with Part 15 of the FCC Rules/Innovation Science and Economic Development Canada’s licenceexempt RSS standard(s). Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation of the device.

WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

License rights and limitations

NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRDPARTY
DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO USE THIRDPARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.

For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

© Inter IKEA Systems B.V. 2023
AA-2416881-1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals