ELING 09BZ445FF 85mm GPS Speedometer Gauge Owner’s Manual
- July 27, 2024
- ELING
Table of Contents
ELING 09BZ445FF 85mm GPS Speedometer Gauge
Before Installation
- Picture B: Before installation, firstly, to open a hole <1>85mm(3 3/8″) of the panel ,make sure there is a space with(55mm backyard of panel)as well
- Picture D: Put the gauge in the hole and screw down.
Diesel engine
Diesel engine
_ ___ Gear number| Speed ratio
Gear number=Speed ratio
Outboard
Outboard
poles| Speed ratio
4| 2
6| 3
8| 4
10| 5
12| 6
Inboard or Gas engine
Inboard or Gas engine
cylinder| cycle| Speed ratio
4| 4| 2
6| 4| 3
8| 4| 4
10| 4| 5
12| 4| 6
Connection
- Black: Ground(-)
- Red: 9-32VDC
- Blue: RPM Signal
- Yellow: Backlight
- White: NC
Installation
- Keep on pressing the rubber button of the backside for 3 seconds, and then enter into setting mode, if you release button more than 3 seconds, it will be out of setting mode.
- The value will increase when you press the button. When you release the button and then press it again, the value will decrease. The longer you press the button, the quicker the value will count up. The minimum step value is 0.1 and the adjustable range is 1.0~360.
- When you get the required speed ratio value after adjustment, please release the button. The tachometer automatically saves the result you set after 3 seconds, If the setup doesn’t meet your demand, please re-setup.
- Short press the button to change the backlight color: Backlight changed in sequence: red (default) → green → blue → white → yellow → cyan →Purple → (automatic). Automatic: Automatically switch the backlight color every 1 minute, Cycle switch according to the above sequence.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>