KITE OPTICS APC 50 Stabilized Binoculars User Manual

KITE OPTICS APC 50 Stabilized Binoculars

APC STABILIZED BINOCULARS

MANUAL AND WARRANTY
We thank you for purchasing a KITE OPTICS instrument.

1. Ocular lenses
2. Twist-up eyecup
3. Diopter ring
4. Eyepieces
5. Neck-strap passageway
6. On-off switch
7. Focus wheel
8. Objective lenses
9. Status LED light
10. Hand-strap passage way

SCOPE OF DELIVERY

• Neoprene Neck-strap
• Softcase with strap
• Ocular lens protection cover
• Objective lens protection cover
• Hand-strap
• USB-C charging cable (APC – Li-ion only)

GET SPARE PARTS

• https://parts.kiteoptics.com

SAFETY

• Never look at the sun or an intense light source with this product. It will damage your eyes.
• Avoid using the device while walking to prevent overlooking obstacles.
• Protect the device from impacts.
• Do not use this product in a location where flammable gas or explosive gas may be present in the air. It may lead to inflammation or an explosion.
• Do not use or store this product in a high-temperature location or a car in mid-summer, at a window, or next to a heating appliance.
• Do not leave exposed to direct sunlight. The lens may concentrate the sun’s rays and cause internal heating of the instrument or fire.
• Be sure to read the instruction manual.
• Avoid using the device near powerful magnetic, electrostatic, or electromagnetic fields to prevent interference.
• Repairs must be conducted solely at authorized service centers, and attempts to dismantle or modify the device may cause damage, injury, or electric shock.
• Avoid exposing the device to insect repellents or aggressive chemicals; use only recommended cleaning agents.
• Keep the device out of reach of small children.
• Avoid touching glass surfaces with fingers, especially if hand creams or insect repellents have been applied, as these substances may contain chemicals harmful to coatings.
• Keep a record of the device’s serial number for loss prevention.

BATTERY INSTRUCTION AND SAFETY

APC AA MODEL

1. 11 Battery covers
2. 12 AA battery compartment

INSERTING THE BATTERIES (batteries not included)

Remove the battery covers on the left and right side by turning them anti- clockwise. Insert 1 AA battery on each side. ‘–‘ side goes in first. close the battery covers by turning them clockwise.

• Always use AA Alkaline or Lithium batteries. DO NOT USE RECHARGABLE BATTERIES, this will void the warranty.
• KITE OPTICS advises the use of Lithium AA batteries over Alkaline batteries, for the best battery life and low risk of battery leakage.
• Always turn off the switch after use. If you do not use the device for a long time, please remove and store the battery.
• In the unlikely event that liquid leaked from the battery gets into your eye, immediately wash it out with a plentiful amount of water and consult a doctor. If it gets on your skin or clothes, wash them with water.
• Do not leave the batteries in the unit for a long time when not in use. The electrolyte solution in the battery may leak, damaging the unit.

STATUS LED

When switched on, the status LED light will inform you of the battery capacity

• Continuous green = 100 % – 30 %
• Continuous orange blinking = < 30 % (low battery indicator)

APC – Li-ion MODEL

• 13. USB-C charge port

This product incorporates a built-in rechargeable battery that cannot be replaced. When utilizing this product, consider the following precautions: Cease use if the outer casing is damaged or if battery damage is suspected. In such instances, promptly contact our customer service to mitigate the risk of explosion and/or accidents. Charge the device using the supplied USB cable and a suitable power source that adheres to local regulations or possesses FCC/CE/IC approval.

CHARGING

Begin by connecting the USB charging cable to the USB-C port on the device. Attach the opposite plug of the cable to a suitable USB power adapter with a minimum input of 1.5 A/5 V for optimal charging times, or another external power source such as a power bank. Ensure the power source meets safety and regulatory standards. Note: Please be cautious during the charging process and follow these instructions diligently to ensure the longevity and safety of your device.

• Status LED light is orange = charging
• Status LED light is green = fully charged

To prevent battery deterioration, please disconnect the product from the power supply device when the status LED turns green.

CHARGING BEHAVIOR :
Per KITE OPTICS experience and thanks to APC power saving functions :

• Battery fully charged = 30 hours of power = up to 2 months of intensive binocular use up to 6 months of average binocular use

STATUS LED
When switching on, the status LED light will inform you of the actual Li- ion battery capacity

• 3x green blink = > 80 %
• 2x blink green = 80 % – 50 %
• 1x blink green = 50 % – 20 %
• Continuous orange blinking = < 20 % (low battery indicator)

GENERAL SAFETY GUIDELINES

• Disconnect the power cord during electric storms or extended periods of non-use.
• Battery life depends on conditions, environmental factors, features, and connected devices.
• Keep the device away from heat sources and avoid covering it during charging.
• Exercise caution to prevent forcing connectors into ports or applying excessive pressure to buttons, as this may void the warranty.
  • Operational temperature: -20 to +45 degrees Celsius
  • Re-charge temperature: 10 to +45 degrees Celsius
  • Storage temperature: -20 to +60 degrees Celsius

SWITCHING THE DEVICE ON/OFF

The device is switched on by placing the power switch in the ‘I’ position. The device is switched off by placing the power switch in the ‘0’ position. The status LED light will be green when the device is switched ON.

SLEEP MODE BY APC
The device is equipped with KITE’s APC system (angle power control). Without having to switch the button, it will put the stabilizing electronics to sleep mode when the instrument is in rest position, and automatically activate the unit when you start observing again. This results in a huge increase in battery life and comfort of use.

• REST POSITION (Hanging from the neck or standing on a table) The instrument is tilted to a vertical position by 60° or more. The stabilization electronics automatically go into SLEEP mode, and the status LED blinks red.
• ACTIVE POSITION (during observation) The instrument is tilted to a horizontal position by 40° or more. The electronics automatically become active, the status LED lights green.

AUTOMATIC OFF BY TIMER

No matter the position the instrument is in (active mode or sleep mode), 90 minutes after placing the switch to ON, the instrument will completely switch OFF again. At this moment the status LED will go dark.

NOTE : When the instrument was in SLEEP mode and automatically entered OFF mode after 90 minutes, the power switch might still be in the ON position. To re-activate the instrument, turn the power switch to OFF and to ON again. The 90-minute cycle starts again.

USE OF THE DEVICE WITHOUT POWER

apart from power on and off, the power switch also acts as a physical lock for the internal gimbal. When the device enters SLEEP mode while the power switch is still in the ON position, the internal gimbal system is no longer actively powered but will be free in movement. This free movement can be felt when shaking the binoculars, or seen when looking through the binoculars as a very unstable and shaky image. In the same way, placing the power switch to an ON position while no batteries are placed or with a dead battery, will cause the gimbal system to be unlocked and move freely. This is normal. You can perfectly use the device as a conventional binocular when no battery is placed or when the battery is dead, only keep in mind to put the power switch in the OFF position so the gimbal is locked.

FIRST USE

• Attach the neck-strap to the neck-strap passageway on both sides.
  • Attach a hand-strap
  • Attach a neck-strap
• For use while wearing spectacles, do not twist up the eyecups. For use without wearing spectacles, twist up the eyecups by turning them anti-clockwise.
• Look through the binoculars and adjust the interpupillary distance by folding the eyepieces in or out, untill you see one nice and round image.
• Adjust the diopter setting. To achieve optimal image quality, the possibly varying visual acuity between the left and right eye must be corrected.
  • Use without eyeglasses and equal acuity of both eyes or with eyeglasses. Place the diopter ring in a middle neutral position. (alignment of indications in diopter wheel and rubber)
  • Use without eyeglasses and varying acuity. Look through the left eyepiece with your left eye and turn the focus wheel to focus sharply on a selected object. Now look at that same object through the right ocular with your right eye and again create a sharp image of this object by turning the diopter ring only. Now the dioptric correction has been set for our particular visual acuity.

OBSERVATION

• Look through the binoculars, keeping in mind the above instructions for first use.
• Depending on the distance of the observed object, adjust the focus by turning the focus wheel.
• Activate the stabilization system by flipping the power switch to the ON position. The status LED turns green.

CARE AND MAINTENANCE

Note : Avoid the instrument being exposed to jolts and shocks, dust, and sand. Cleaning of the lenses: Always remove large particles first, using a soft brush or by blowing them away. Large particles such as sand and salt could cause scratches on the lens surface during cleaning. For thorough cleaning, we recommend breathing onto the lens surface to form a coat of condensation and then cleaning it with a soft and moist cloth. Never press hard or use force while wiping the lenses. We advise not to use liquids meant for spectacle cleaning unless they are advised for binoculars. Some liquids can cause damage to the coatings of your binoculars.

LONG-TERM STORAGE OF THE APC – Li-ion MODEL
When in llong-termstorage, to prevent battery deterioration, please charge the battery once every six months. The built-in rechargeable battery will naturally discharge even if it is charged and stored. When storing for a long time, the recommended charging time is approximately 50 minutes. Disconnect the product from the power source even if the charging indicator is still orange.

STORAGE

• Keep your device stored in its bag in a well-ventilated area. In case of moisture exposure, ensure thorough drying before storage. In high-humidity or tropical environments, consider using an airtight container with a moisture-absorbing agent (e.g., silica gel).
• Avoid subjecting the device to excessive heat, such as direct sunlight or fire.
• Avoid storing in areas with dramatic temperature changes.
• Using damaged cables or chargers, or charging in humid environments, may result in electric shocks, fire, injury, or equipment damage.
• Refrain from attempting to remove the rechargeable lithium-ion battery; contact us or an authorized dealer for assistance.
• Do not leave the batteries in the unit for a long time when not in use. The electrolyte solution in the battery may leak, damaging the unit.

WARRANTY 30 YEARS *5 YEARS ON ELECTRONICS

The warranty period of your instrument starts on the date of purchase by the following conditions: In case of manufacturing faults or defects in material not caused by the user, we take on material and workmanship costs. We reserve the right to repair or replace the instrument or the defective part at our discretion. This warranty is not valid when the defect has been caused by improper handling of the instrument, or in case of accidents. Wear parts like eyecups, leather details, armoring, carry straps and accessories are also exempt from the warranty. The same applies to surface damage. In that case, thanks to the excellent after-sales service of KITE Optics, the costs of materials and workmanship wil be brought to a minimum. It is in our philosophy and reputation to offer our customers the very best after-sales service available in the world of sports optics. In a warranty case or for repair work, present the instrument together with this card to your authorized KITE Optics dealer. An instrument sent in without this card can not be repaired free of cost. Warning! The warranty is not valid when the product has been serviced or repaired by a person or repair shop that is not authorized by KITE Optics. Never try to repair or make modifications to the instrument yourself. NOTE. The device is splash-, water-, and dust-resistant, rated IPX7 under controlled laboratory conditions. This resistance may diminish over time due to wear and tear, and damage caused by liquids is therefore not guaranteed to be covered by the warranty.

COMPLIANCE

CE MARK
The CE mark signifies compliance with fundamental EU guidelines.

DISPOSAL OF ELECTRICAL AND ELECTRONIC EQUIPMENT
(For EU and European countries with waste separation policies) Dispose of this device, containing electric/electronic components, at a designated recycling collection point provided by local authorities. Standard or rechargeable batteries must be removed and disposed of separately in line with local regulations.

• Vlamingveld 89 8490 Jabbeke Belgium
• T +32 50 69 23 19
• www.kiteoptics.com
• info@kiteoptics.com

References

• Kite Optics • Nature & Hunting | Binoculars telescopes riflescopes
• parts.kiteoptics.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>