LIUYU LILI NP11888 Inflatable Bathtub Instructions
- July 25, 2024
- LIUYU LILI
Table of Contents
LIUYU LILI NP11888 Inflatable Bathtub
Product Information
Specifications :
- Product Name : Inflatable Bathtub Aufblasbare Badewanne
- Model Number: NP11888
Product Usage Instructions
Installation
Installation Site Requirements
Important Tips: The ground should be smooth and flat, and there should be no sharp objects. Users should also consider the total weight of the user, tub, and water to ensure that the ground has sufficient strength to support it. Make sure there is a good water drainage system close to the installation area. If the tub is installed in a place that does not meet the safety requirements, it may cause unnecessary loss to the user.
Tub Assembly
Warning: Please only use the included hand pump to inflate the tub and do not over-inflate it. Please do not use other electronic or high-pressure air pumps for inflation. Excessive pressure will cause the tub to burst or damage the seams of the tub.
1.3 Fill the Tub with Water
Tub Maintenance
2.1 Water Maintenance
We recommend keeping the PH value of the water in the tub between 6.5 and 8.5. A PH value outside of this range can shorten the service life of the tub and cause irritation or damage to your skin. We suggest using PH test paper to routinely test the water quality before using it.
2.2 Water Treatment
It is important to keep the water in the tub clean, then we suggest the following:
- Before using pool chemicals, please consult your local pool supply store for additional maintenance information.
- Pay close attention to and follow the chemical manufacturer’s instructions.
- We recommend that you use bromine reagents after each use of the tub.
Warning: Let any chemical agents fully dissolve and mix into the water before using the tub. Do not exceed the manufacturer’s recommended usage of chemicals in the tub. We do not recommend using harsher chemicals such as chlorine in the tub.
2.3 Cleaning the Tub
Dirt from the body and clothes, and contaminants in the water can easily adhere to the surface of the tub. It is necessary to frequently wipe down the surface of the tub with a soft cloth and a neutral detergent. A fine, soft brush can be used to gently scrub the water inlet and outlet to prevent scaling and calcification from forming around them.
Note: Do not use hard bristle brushes to clean the surface of the tub.
FAQ
- Q: Can I use chlorine for water treatment?
- A: We do not recommend using harsher chemicals such as chlorine in the tub. It is suggested to use bromine reagents for water treatment
- Q: What should I do if I encounter any issues during assembly?
- A: If you encounter any issues during assembly, please contact our technical support for assistance.
Before You Start
Please read all instructions carefully.
Retain instructions for future reference.
Separate and count all parts and hardware.
Read through each step carefully and follow the proper order.
We recommend that, where possible, all items are assembled near to the area in
which they will be placed in use, to avoid moving the product unnecessarily
once assembled.
Always place the product on a flat, steady and stable surface.
Keep all small parts and packaging materials for this product away from babies
and children as they potentially pose a serious choking hazard.
WARNING:
SAFETY AND OPERATIONAL WARNINGS
- Before using this product, it is essential to read this entire manual and all instructions. This plunge tub is intended for use solely in the manner described in this manual.
- It is recommended to consult a physician before beginning your cold plunge therapy regimen.
- Please do not leave children unattended around the bathtub.Extra caution must be taken to prevent unauthorized entry by children. When not in use, please make sure to cover it with the included cover.
- Pets should be kept away from the tub to avoid damage and injury.
- Never operate any electrical appliance when in the tub or when your body is wet. Do not place any electric appliances, such as lights, telephones, radios, or televisions within 5 feet (1.5 m) of the tub.
- The use of alcohol, drugs, or medication before or during the cold plunge may lead to loss of consciousness with the possibility of drowning.
- Persons with a history of heart disease, low or high blood pressure, circulatory system problems, or diabetes should consult a physician before they use a Cold Plunge Tub.
- Persons using medication should consult a physician before using a tub since some medications may induce drowsiness while other medications may affect heart rate, blood pressure, and circulation.
- Prolonged immersion in water below 70oF (21oC) can pose a risk of hypothermia. Please note that the core body temperature can continue to drop even after emerging from the cold plunge tub.
- Do not operate tools or heavy machinery or attempt to drive immediately after completing a cold plunge.
- Always enter the cold plunge tub feet first and breathe continuously in a steady, structured rhythm. Do not attempt to hyperventilate or hold your breath while immersed in the tub.
- Exit the tub immediately if there are any feelings of weakness, exhaustion, or being unable to control your fingers, hands, arms, and legs.
- Improper assembly and operation can result in severe personal injury as well as product failure. Please follow all instructions carefully or contact technical support for assistance.
PACKAGE CONTENTS
| Item | Qty. | Description |
|---|
1
|
1
|
Circular pool
2
|
1
|
Circular pool cover
3
|
6
|
Pool pipe
4
|
1
|
Faucet switch
5
|
1
|
Drainage pipe
6
|
2
|
Repair subsidy
7| 1| Hand pump
Installation
Installation Site Requirements
- Place the tub on a flat, stable surface that can bear the full weight of the tub when filled with water and a person inside.
- Please ensure that there is water drainage available around the tub.
Important Tips:
The ground should be smooth and flat, and there should be no sharp objects. Users should also consider the total weight of the user, tub, and water to ensure that the ground has sufficient strength to support it. Make sure there is a good water drainage system close the installation area. If the tub is installed in a place that does not meet the safety requirements, it may cause unnecessary loss to the user.
-
Indoor installation:
- Some special requirements for indoor installation that need attention:
- During the filling and draining of water, water may spill on the ground. We strongly suggest that the tub only be installed near floor drains and on moisture-proof surfaces.
- There should be no items nor appliances that are easily affected or damaged by moisture or water in the immediate area around the tub.
To ensure air quality and user comfort, the tub must be installed in a well- ventilated environment.
Note : Do not install the tub on carpets or other surfaces that are easily damaged by water.
-
Outdoor installation:
- The ground where the tub is on must be smooth and flat with no sharp objects such as branches and stones nearby. Be sure to use the included floor mat for additional protection.
- Do not expose the tub to direct sunlight for prolonged periods of time. This will shorten the service life of the tub. We recommend covering the tub or placing it in a shaded area when not in use.
- There should be a good water drainage system near the tub.
Tub Assembly
Warning: Please only use the included hand pump to inflate the tub and do not over-inflate it. Please do not use other electronic or high-pressure air pumps for inflation. Excessive pressure will cause the tub to burst or damage the seams of the tub.
Fill the Tub with Water
Fill the tub with water using a water hose until there is sufficient water to be able to submerge your entire upper body underwater. Leave enough room for your head to be fully above the water line. In most cases, this would be at about 70% of the plunge pool.
Note : Overfilling the plunge pool will result in water spilling out and over the sides of the pool when you enter. Please be mindful of any electronics, power cords, outlets, etc around the plunge pool. We highly recommend starting with less water and then adding more as needed to submerge your entire upper body.
Tub Maintenance
Water Maintenance
We recommend keeping the PH value of the water in the tub between 6.5 and 8.5. A PH value outside of this range can shorten the service life of the tub and cause irritation or damage to your skin. We suggest using PH test paper to routinely test the water quality before using it.
Water Treatment
It is important to keep the water in the tub clean, then we suggest the following:
-
Cover the tub whenever it’s not in use to prevent debris or other particles from falling in.
-
Replace the water in the tub every 3 days and then clean the tub with a clean cloth.
-
The tub can be treated and disinfected with suitable pool chemicals such as bromine. Be sure to follow instructions on the packaging of the cleaning agents. Please consult a pool supply store for additional details before use.
Before using pool chemicals, please consult your local pool supply store for additional maintenance information. Pay close attention to and follow the chemical manufacturer’s instructions. Improper use of pool cleaning chemicals may result in damage to the pool. -
We recommend that you use bromine reagents after each use of the tub. You can use a chemical floater (Fig.1), or directly spread a bromine powder or liquid into the water. Always add the pool chemical to the water and never add pool chemicals to an empty tub.
Warning : Let any chemical agents fully dissolve and mix into the water before using the tub. Do not exceed the manufacturer’s recommended usage of chemicals in the tub. We do not recommend using harsher chemicals such as chlorine in the tub.
Cleaning the Tub
Dirt from the body and clothes, and contaminants in the water can easily
adhere to the surface of tub. It is necessary to frequently wipe down the
surface of the tub with a soft cloth and a neutral detergent. A fine, soft
brush can be used to gently scrub the water inlet and outlet to prevent
scaling and calcification to form around the water inlet and outlet.
Note : Do not use hard bristle brushes to clean the surface of the tub.
Tub Repair
There is an included repair kit with a repair patch, should there be a puncture in the tub causing it to leak air. Before repair, the tub should be drained and deflated, and the damaged section should be wiped clean with some alcohol. Apply the attached repair patch to the leaking area and let it sit for 30 minutes before it can be used.
Tub Storage
Proper care and storage will prolong the service life of the tub. Before storing the tub, completely drain all water from the tub and wipe it down clean with a soft cotton cloth or towel. It is recommended to place the tub in the included storage bag and store it in a cool dry place.
Note : Do not store the tub in an environment below zero degrees Celsius or under direct sunlight for extended periods of time. The tub shell will fade or become brittle and shorten the overall life of the tub.
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
USA office : Fontana
AUS office : Truganina
ITA office: Milano
POL office: Gdańsk
DEU office: FDS GmbH, Neuer Höltigbaum 36, 22143 Hamburg, Deutschland FRA office: Saint Vigor d’Ymonville
GBR office: FDS Corporation Limited, Unit 4, Blackacre Road, Great Blakenham, Ipswich, Ip6 0FL, United Kingdom
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>