Puig HONDA REBEL 500 Instruction Manual
- June 3, 2024
- Puig
Table of Contents
Puig HONDA REBEL 500 Instruction Manual
INSTRUCTIONS TO ASSEMBLE
Remove the fasteners that subject the chassis to the engine. Mount the
protectors on each own side as the figure below shows. Tight the set, and
place the caps.
All the screws replaced, should be tightened to the torque specified in the
oem maintenance manual for your motorcycle. if no torque specifications are
provided in the oem maintenance manual, may be used 54Nm for all M10 screws.
Medium strength liquid thread-locker (i.e. “Loctite”) should be used to secure
all screws, bolts and nuts. All screws, bolts and nuts should be checked after
driving the first 50 km to ensure that all are tightened to the proper torque.
FOR TO ASSEMBLE THE CRASH PADS, IF YOU ARE NOT A TRAINED MECHANIC, PLEASE
CONTACT A SPECIALIST. MOTOPLASTIC, S.A. TAKES NO RESPONSIBILITY FOR DAMAGES
CAUSED BY IMPROPER INSTALLATION.
THE USE OF CRASH PADS DO NOT GUARANTEE A FULL PROTECTION IN CASE OF ACCIDENT.
MOTOPLASTIC-PUIG DECLINE ANY RESPONSIBILITY IN CASE OF MOTORCYCLE DAMAGE.
| ID. | PART | DESCRIPTION | QTY. | REF.: |
|---|---|---|---|---|
| 1 | __ | M10/150×180 DIN912 screw | 2 | TORNIAD912–364 |
| 2 | __ | M10 DIN125/A washer | 2 | M2AM10DIN125AZB |
__
3
| | Customacces Vintage nylon protector| __
2
| CRASHPADCUSTOM
4
| | Black aluminum spacer (Black)| __
2
| CASQU470-0-1770
5| | M10 DIN6923 nut| 2| TUERCAD6923M10Z
The right side assembly is shown as an example, so the same steps can be
performed for the left side assembly
CONSULT OUR WEBSITE THE VIDEO MOUNT AVAILABILITY OF THIS REFERENCE.
Scan Me
Customer Support
www.puigusa.com
info@puigusa.com
www.puig.tv
info@puig.tv
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>