Puig 21242N Pro 2.0 Frame Sliders Instruction Manual
- October 30, 2023
- Puig
Table of Contents
HONDA NC700S/X ’12-’13
HONDA NC750S/X ’14-’22
21242N Pro 2.0 Frame Sliders
Instruction Manualhttps://puig.tv/es/tuning-motos/protectores-de-motor
/protectores-de-motor-pro?bike=29585
INSTRUCTIONS TO ASSEMBLE
Remove the fasteners that subject the chassis to the engine. Mount the
protectors on each own side as the figure below shows. Tight the set, and
place the caps.
All the screws replaced, should be tightened to the torque specified in the
oem maintenance manual for your motorcycle. if no torque specifications are
provided in the oem maintenance manual, may be used 54Nm for all M10 screws.
Medium strength liquid thread-locker (i.e. “Loctite”) should be used to secure
all screws, bolts and nuts. All screws, bolts and nuts should be checked after
driving the first 50 km to ensure that all are tightened to the proper torque.
FOR TO ASSEMBLE THE CRASH PADS, IF YOU ARE NOT A TRAINED MECHANIC, PLEASE
CONTACT A SPECIALIST. MOTOPLASTIC, S.A. TAKES NO RESPONSIBILITY FOR DAMAGES
CAUSED BY IMPROPER INSTALLATION. THE USE OF CRASH PADS DO NOT GUARANTEE A FULL
PROTECTION IN CASE OF ACCIDENT. MOTOPLASTIC-PUIG DECLINE ANY RESPONSIBILITY IN
CASE OF MOTORCYCLE DAMAGE.
Accessory verified in the basic configuration of the motorcycle. For models
with extra factory settings. We cannot assure its compatibility, except for
prior consultation. We decline any eventual claim.
| ID. | DESCRIPTION |
|---|---|
| 1 | Caps set |
| 2 | M10/150X65 screw DIN912 |
| 3 | M10/150X90 screw DIN912 |
| 4 | M10 washer |
| 5 | Ø20outer Ø12inner x2 washer |
| 6 | PRO protector set 2.0 |
| 7 | Aluminium cylinder right side |
| 8 | Aluminium cylinder left side |
| 9 | Right offset |
| 10 | Left offset |
| 11 | M12/125×60 screw |
| 12 | M12/125×90 screw |
| 13 | M12 washer |
MOUNTING INSTRUCTIONS
LEFT SIDE
-
ASSEMBLY MONTAJE
RIGHT SIDE
-
ASSEMBLY MONTAJE
Created by: www.rrdisseny.cat
www.puig.tv
www.puigusa.com
info@puig.tv
info@puigusa.com