SHARPER IMAGE SY20B24GA Drone 7 inch Flying Car Instruction Manual
- June 6, 2024
- Sharper Image
Table of Contents
SHARPER IMAGE SY20B24GA Drone 7 inch Flying Car Instruction Manual
Getting to Know Your Drone
PLEASE READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO USE. KEEP THIS DOCUMENT
AS IT CONTAINS IMPORTANT INFORMATION ABOUT YOUR DRONE
Prepare for Flight
- Drone must be charged before each use (Cable included)
- Indicator light will turn off once fully charged
- Install batteries in remote
PAIR YOUR DRONE
Before each flight pair the remote with the drone:
- Turn your drone on and place on a flat, level surface
- Turn on the remote on and move the left joystick up, then down
- The beep will indicate successful pairing
- Repeat steps 1 and 2 if necessary
Remote Control Overview
- Practice flying your drone below 10 feet and at low speeds until comfortable with all controls to avoid unnecessary damage or injury
- Left joystick: left/right controls spin and Up/Down controls elevation
- Right joystick: controls flight direction
- Direction Trim: use to eliminate drift To cut power to drone, move left joystick to down position
ADULT ASSEMBLY, CHARGING, AND BATTERY INSTALLATION IS REQUIRED. ADULT SUPERVISION IS REQUIRED
WARNING:
CHOKING HAZARD – Small Parts not for Children under Steers.
CUSTOMER SERVICE
800-374-2744
Before coifing please locate the–IQ-digit code printed on the back of your
remote
INTRODUCTION
Congratulations on your purchase of the Rechargeable 2.4 GHz Car Drone. Get ready to soar to new heights. Master the art of drone flying with remote control maneuverability. This lightweight drone will provide hours of fun
SPECIFICATIONS Drone Battery: 800 mAh Li-po
Remote Controller Battery: 4 x 1.5V `AA” Charging Time: 120 minutes
Maximum Recommended Altitude: 100 ft.
READ ALL WARNINGS AND PRECAUTIONS BEFORE USE
WARNING: Changes or modifications. the unit not expressly approved by the pady responsible for compliance could void the user’s authority to operate the equipment. Fly-sways are the responsibility of the individual pilot and will not be replaced by the manufacturer
CONTENTS
REMOTE BATTERY INFORMATION
- Unscrew the remote battery door using a Philips head screwdriver (not included).
- Install 4 “AA. batteries as shown in the diagram above.
- Replace and close battery compartment
LITHIUM-POLYMER BATTERY WARNING
There is a risk of fire and personal injury if Li-Po battery is punctured, damaged or misused.
- Never expose battery to extreme temperatures or moisture
- Do not subject battery to strong Impacts.
- Always keep battery away from flammable
- Only use manufacturer specified batter(ies), charger*, and/or adapters, d applicable. Battery Is not serviceable.
- Let battery cool to room temperature before char,
- While charging, never leave battery unattended
- Recycle or dispose of battery according to federal, state and local laws.
KEEP THIS INSTRUCTION MANUAL FOR REFERENCE
CHARGING BATTERY
Note: The Battery Charger will light up when His charging the battery and turn off when the battery is fully charged. Charge time is approximately 120 minutes
- Turn off the drone before charging.
- Connect the Battery Charger Cable to the port found on the rear of the drone.
- Connect USB connector to the power source
Replacing Propellers
- Propellers are secured by screws. Only an adult should replace blades. To remove, unscrew the blade and pull up.
- Replace propellers by following the diagram on the right.
- Each blade spins differently. Blade 1 turns counter clockwise and Blade 2 turns clockwise
REMOTE OVERVIEW
OPERATING DRONE
Step 1 – Pre-Flight Checklist
- Read all warnings and instructions
- Install remote batten., page 2
- Charge batteries, page 3.
- Make sure that drone and remote are powered off
Step 2 – Choosing a location
- Drone is designed to be flown/driven indoors and outdoors
- Always make sure you have enough space to fly drone
- Always follow warnings, page 1
Step 3 – Driving Mode
Step 4 – Lift OR
Step 5 – Operating Drone in Flight
Follow this step if your drone begins to drift while take off or during flight.
- F. Drone drifts backwards: Press the Forward Adjustment Button.
- B. Drone drifts forwards: Press the Backwards Adjustment Button.
- L. Drone drifts right: Press the Left Adjustment Button.
- R. Drone drifts Left: Press the Right Adjustment Button
Step 6 – Landing Drone
- Make sure you have achieved level, balanced flight, where the drone is neither climbing nor This mode allows you to safely and slowly land your drone without having to control the speed.
- The ideal auto landing height is 20ft.
- Press the land button to trigger auto land. Remote will beep continuously until you exit the auto land mode.
- To steer the drone during landing, use the right control until drone has reached the
- Press the land button again to exit auto landing mode.
Step 7 – Retrieving Drone
- Turn off your remote by pressing the Power This will stop you from accidentally turning the propellers on.
- Make sure the propellers have stopped spinning then pick up your
Note: You will need to pair your drone again before your next flight.
Align
Press the Align Button to turn Align mode ON and then again to turn off.
- In this mode, the drone will always move in the direction you press the Multi Directional Button no matter which way the drone faces
Tips
- Do not crash drone into sand or dirt. Drone gears may become clogged.
- When first learning to fly, practice lifting on and hovering.
- Stay several feet from walls and buildings.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>