Kudoushi T1 TWS 12 Black Mini Bluetooth Wireless Headset User Manual

Kudoushi T1 TWS 12 Black Mini Bluetooth Wireless Headset

Power On/Off

• Power On
  Open the charging case, the earbuds will automatically power on.

• Power Off
  Place the earbuds back into the charging case and close the case, the earbuds will automatically power off.

Paring & Re-pairing

1. Open the charging case and take both Earbuds out of the charging case and the twin Earbuds will power on and pair with each other automatically.
2. Active Bluetooth setting on your device, search and choose to connect to You.
3. The earbuds can remember previously paired devices. When you make the second connection, simply activate the Bluetooth in your devices, and take out both earbuds from the charging case. They will reconnect to your device automatically. If the earbuds doesn’t automatically connect to your device, please activate the Bluetooth in your device and click on the Bluetooth list.
4. Mono mode: When Bluetooth connected, you can use either one of the earbuds only by putting the other one back into the charging case and closing the cover.

Factory Reset

Try the following steps if you fail to build a connection between the earbuds and the device:

1. Clear pairing record between the earbuds and all your devices.
2. Take out the headphones and turn off the two flashlights, then click on the connection.

LED Indicator Behavior

Specifications

Control

Stereo Mode

Mono Mode

Charging

Charging the earbuds
When the headset is low, it will be below the power prompt.

1. When the charging case is powered, put the earbuds into the charging case and close the charging case, the earbuds will charge automatically.

Charging the charging case
When the charging case battery is low, the LED indicator of the charging case is rapidly flashing in red.

1. Please use the provided USB-C cable to charge the charging case directly.
2. During charging, the LED indicator of the charging case is rapidly flashing in red. When the case is fully charged, the LED indicators will turn red.

NOTE:
Fully charge both the earbuds and the charging case before the first use.

Warranty

We provide warranty service in accordance with the national three-guarantee policy.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>