Trust ZWLD-100 Water Leakage Detector User Manual
- June 9, 2024
- Trust
Table of Contents
PREMIUM-LINE
ZWLD-100
WATER LEAKAGE DETECTOR
USER MANUAL
ZWLD-100 Water Leakage Detector
**COMPATIBILITY
**
The water leakage detector works with the Smart Bridge and the ICS-2000 to
receive push notifications when water is detected.
NOTE: For receiving push notifications, a fully working internet connection is
required.
-
(RE)PLACE THE BATTERIES
A Remove the battery cover (backplate) by sliding it from the water leakage detector B Place 2x AAA batteries (not included) in the detector.
Note the positive and negative polarity in the compartment. Close the battery cover. -
DOWNLOAD APP
To connect the detector with a Smart Bridge or ICS-2000, first get the App by scanning the QR code or go to trust.com/zigbee and install it. -
CONNECT DETECTOR
A In the App, select a room, press the + button and choose Trust Zigbee line/Water leakage detector and follow the instructions. For manual set up of push-notifications go to the rules tab, press the + button and select notification wizard. -
INDICATORS
The detector contains a LED indicator to show the status of the detector.
LED FUNCTION TABLE Connection mode| LED will flash fast for approximately 1 min.
---|---
Connected successfully| LED will light up for 3 sec (The App will also indicate when the connection is successful)
Water detected| Red LED will light up once (The App will also indicate when water is detected)
Detector reset| LED will flash 6x -
MOUNT THE DETECTOR
A Remove the plastic layer from the double sided-tape on the back of the detector and place it on a flat service on the wall in a place with a risk of leakage.
B Remove the plastic layer from the double sided-tape on the white sensor at the end of the cable and place it firmly on the floor.
RESET DETECTOR AND ACTIVATE CONNECT MODE
Warning: This step will disconnect the detector from the Smart Bridge or the ICS2000. To reset the detector press the button in the hole at the side for approximately 5 sec with the included pin. The LED will flash 6x to confirm the reset.
Activate connect mode: After resetting the detector you can activate the
connect mode by pressing the button in the hole on the side for approx.
2 sec. The LED will flash fast for 1 minute to indicate the connection mode.
DISCLAIMER
This product is used as a warning device to aid the user in detecting a water
leakage.
However, it remains the responsibility of the end-user to detect and prevent
water from leaking. Therefore Trust cannot be held responsible or liable for
any water damages and injuries resulting from any subsequent damages.
TECHNICAL SPECIFICATIONS
| Zigbee | 2400-2483.5 MHz; 8 dBm |
|---|---|
| Battery | 2x AAA Alkaline Batteries |
| Size | Body HxWxL: 76 x 37 x 17 mm |
Sensor HxWxL: 29 x 27 x 12 mm
Item 71216 Version 1.0
Always read the instructions
before using this product
www.trust.com/zigbee
References
- Trust.com - Home
- Trust.com - Contact & Support - Compliance
- Trust.com - Contact & Support - Installation of ZigBee products
- Trust.com - Home
- Trust.com - Home
- Trust.com - Zigbee Water Leakage Detector ZWLD-100
- Trust.com - Contact & Support - Compliance
- Trust.com - Contact & Support - Safety information
- Trust.com - Contact & Support - Warranty conditions
- Trust.com - Contact & Support - Installation of ZigBee products
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>