WANGMUMU B0B2MYLZBQ Belt Loop Foot Instructions
- July 16, 2024
- WANGMUMU
Table of Contents
WANGMUMU B0B2MYLZBQ Belt Loop Foot
Specifications
| Article Number | 502040 51 10 |
|---|---|
| Compatible Needles | C & E |
| Tape Width | 1″- 1 1/4″ (25-28mm) |
| Extended Tail Length | 2″ (50mm) |
FAQ
- What is the purpose of the belt-loop foot?
- The belt-loop foot is used to fold bias or straight binding and turn it into straps or belt loops quickly and easily using the cover- or chain stitch.
- What type of needles should be used with the belt-loop foot?
- The belt-loop foot should be used with needles C & E.
- What width of tape can be used with the belt-loop foot?
- The belt-loop foot can accommodate tape widths of 1″ to 1 1/4″ (25-28mm).
- How should the tape be prepared before inserting it into the belt-loop foot?
- For easier insertion, trim the fabric corners of the tape. Use tweezers to feed the tape through the slot on the front of the foot.
- How long should the tail of the bias tape be extended behind the foot?
- The tail of the bias tape should be extended 2″ (50mm) behind the foot.
The belt-loop foot is used to fold bias or straight binding, which it then
quickly and easily turns into straps or belt loops with the cover- or chain
stitch.
Article number : 502040 51 10
Instruction
- Set machine for “Coverstich”, using needles C & E.
- Note: 1″ – 1 1/4″ (25-28mm) width tape can be used (cut bias for more flexibility).
- Raise the presser foot and snap on the “Belt-loop foot”.
- For easier insertion into the belt-loop foot, trim fabric corners.
- Insert the tape into the guide by using the tweezers to feed through the slot on the front of the foot.
- Extend the tail of bias tape 2″ (50mm) behind the foot.
- Lower presser foot and sew, belt loops are created without fabric underneath.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>