Model 3 / Y 9.6 inch Car Play Instrument Cluster Head Up Touch Display Instructions

Table of Contents

Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display-
PRO

Specifications:

Model: 3 / Y 9.6-inch CarPlay Instrument Cluster Head-up Touch Display
Screen Size: 9.6 inches
Compatibility: Model 3 and Model Y vehicles
Installation: Requires connection to rear OBD interface and wiring harness routing

Installation Steps:

Pry open the cover below the rear air conditioning.
Connect the display to the rear OBD interface and install the upper cover (conceal multiple plugs in the lower vent if applicable).
Pull the wiring harness down towards the area below the steering wheel, thread it through the hole in the steering wheel, and secure it to the trim panel.
Adjust control settings by lowering the steering wheel to its lowest position and turning it to the left.
Tear off the 3M adhesive, position the display in the center, connect the plug, and conceal it.

Wiring Harness Routing:
Follow the wiring harness routing diagram provided to ensure proper installation and hiding of wires.

Control Settings Adjustment:
To adjust control settings, lower the steering wheel to its lowest position and turn it to the left.

Frequently Asked Questions (FAQ):

Q: Can this display be installed in any car?
A: No, this display is specifically designed for use in Model 3 and Model Y vehicles.
Q: Do I need special tools for installation?
A: Basic tools like a pry tool may be needed for installation, but no special tools are required.

Check whether the product list is complete and damaged before installation.
The installation instructions may be slightly different from the actual operation. If there is any difference, please contact us or according to the actual situation.
Warning: Do not remove any parts by yourself. Any improper operation is not covered by the warranty.
Before installing the product, please turn off the vehicle power and cut off the battery negative pole of the frunk.
Please watch the installation video and instructions carefully before the installation.
Please confirm whether the installation and wiring are correct before testing after installation.
Check whether the installed product functions normally. If there is any problem, please check whether the plug is plugged tightly.
Check whether the function of the original vehicle is used normally. If there is any problem, please check whether the plug is plugged in tightly.
Please do not install the product if you receive a damaged item. Please take photos immediately and provide them to our after-sales team for confirmation. Photos should be provided that include all parts of the product and can display the damage. (If the product is notified of the damage after installation, claims and reissues will not be accepted, and you will need to purchase the parts again at your own expense.)

Pry open the cover below the rear air conditioning. $Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display- $1$$
Connect it to the rear OBD interface, then install the upper cover (if there are multiple plugs, you can conceal the min the lower vent). $Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display- $2$$
Pull the wiring harness down towards the area below the steering wheel, pry open the cover, and thread it through the hole in the steering wheel as described above. $Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display- $3$$
Adjust the control settings by lowering the steering wheel to its lowest position and turning it to the left. $Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display- $4$$
Tear off the 3M adhesive, position it in the center, connect the plug, and then conceal the plug. $Model-3-Y-9-6-inch-Car-Play-Instrument-Cluster-Head-Up-Touch-Display- $5$$