MAXIM LIGHTING 58710 Wafer Led Flush Moutn Instruction Manual

MAXIM LIGHTING 58710 Wafer Led Flush Mount

LED LOW-VOLTAGE INSTRUCTIONS

Before Getting Started

• Read the instructions carefully prior to assembling the product.
• When you open the package with a sharp tool like a box knife, be careful not to damage the components Inside.
• Carefully remove all packaging materials and retain for future use.
• Keep all hardware parts and packaging out of reach or small children.
• Choose a dean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
• Ensure that you have all required contents for complete assembly.
• Take care when lifting. Assemble the product In dose proximity to where it is intend to install it.
• Do not over tighten the screws and bolts as this may damage the threads.
• Do not let children play with this product.

Risk of suffocation: Keep packaging materials away from children.

Lamp Care Instructions

• Carefully read through the Instruction sheet before assembly and using the product.
• Caution there is a risk of shock: Disconnect from power source before assembling or cleaning.
• Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
• Only use the recommended bulb type and do not exceed the maximum wattage as it could cause fire.
• Check the product cord to be sure is free torn or frayed.

WARNING : Wires must to be connected to low voltage driver and should not be connected directly to live wire or a short may occur.

Cleaning & Maintenance

• On polished finishes, often using ta le powder can reduce the appearance of fingerprints and other smudges.
• For respective shade surfaces, use the appropriate cleaners, i.e. glass cleaner, stone polish, & wood polish.
• Clean with soft cloth and a mild detergent. Do not use abrasive or harsh cleaners.
• Periodically (every 90-180 days) make sure that the screws are fully tightened.
• Prolonged exposure to heat sources may cause glazing, melting and scorching, or even cause color to fade.

Contents:
Before getting started, ensure the package contains the following components:

Mounting Instructions

1. Prior to installation, install the mounting plate on the junction box with mounting screws. Drive screws completely to the end of the junction box.
2. Connect supply wires to wires on fixture with wirenuts. Connect white to white, black to black and green wire to green wire as grounding connection.
3. Completing the installation by pushing the fixture into the mounting plate.

WIRING DIAGRAM

Verified list of tested drivers:

• Lutron Diva DVCL-153P
• Lutron Diva DVELV-300P
• Lutron Caseta
• DEAKO-Smart Dimmer
• DEAKO-Single Dimmer
• Leviton Sureslide 6613-P
• Leviton Illumatech IPI06-1LZ
• Leviton Decora 6674

GENERAL COMPATIBILITY

• FORWARD PHASE
• REVERSE PHASE
• ONLY at 120VAC
• Due to In rush current, wattage should not exceed 150W on a 600W dimmer.

IMPORTANT!

If the control is not paired properly to LED fixtures, irreparable damage may occur. If the dimmer you are using is not listed here, consult a lighting professional or view our Dimming Compatibility Chart online:
https://www.maximlighting.com/led-dimmer.

Documents / Resources

| MAXIM LIGHTING 58710 Wafer Led Flush Moutn [pdf] Instruction Manual
58710 Wafer Led Flush Moutn, 58710, Wafer Led Flush Moutn, Led Flush Moutn, Flush Moutn, Moutn
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>