HAVIT W3037 3 In 1 Wireless Charger User Manual
- July 12, 2024
- havit
Table of Contents
HAVIT W3037 3 In 1 Wireless Charger
Packing list
-
3in 1 wireless charger *1
-
33W USB–C travel charger *1
-
Manual*1
-
USB-C to USB-C cable*1
-
Warranty card*1
Product Structure
Specification
Product Model: W3037 kit
Product Name: 3 in 1 Wireless Charger
-
3 in 1 Wireless Charger Product Parameters
Material: ABS+ aluminium alloy
lnput 9V 3A
Output:
Phone: 15W [compatible with 7.SW and SW)
Watch:2.SW
Earbuds: 3W {max)
Product Size: 704″704″760mm
Weight: 176g±Sg -
Mini 33W USB-C Travel Charger Product Parameters
Material: ABS
Input: 100-240V~S0/60Hz 0.SA
Output:
USB-C: 5.0Y 3.0A, 9.0V= 3.0A, 72.0V= 2.SA
(PD30W)
PPS: 3.3V-5.9V 3.0A, 3.3-71.0V = 3.0A (33W)
Size: 34’35′”68mm
Weight: 42g±5g
Instructions for use
-
Power supply
-
Plug one end of the USB-C charging cable into the equipped 33W power adapter, and the other end into the USB-C port of the product; the product will enter normal working status
-
Wireless charging
-
This product can wirelessly charge three devices: mobile phone, earphones, and watch at the same time
-
The watch charging module is compatible with wireless charging of Apple and Samsung watches
-
Wireless charging status indication (mobile phones and earphones have charging indicator lights on their displays, but watches have no charging indicator lights)
Power on: the light flashes twice and then goes out;
Standby: no light;
Charging: always on;
Fully charged: the light turns off {some
Apple phones do not support this function);
FOD: Flashing light. -
Ambient lighting
-
Click the ambient light touch SWitch to turn on the ambient light; click to SV11itch the lighting effect each time; double-click to turn off the ambient light.
-
There are 8 kinds of lighting effects; the order is: overall colorful gradient, colorful rotation, purple+ yellow+ light blue three-color rotation, red, green, blue, purple, automatic cycle (green-blue-yellow-red)
Warning
*Special note: If the alarm clock, wireless charger, clock, and night light are required to work at the same time, please be sure to use a QC3.0 or above power adapter or PD adapter, when powered bye voltage, the wireless charger does not support fast charging.
- Please do not disassemble this product by yourself
- Please do not place this product near heat sources
- Please do not place the product near water or in wet places.
- Please do not place it too close to a magnetic card with a magnetic stripe or chip (ID card, bankcard, etc.) to avoid failure of the magnetic card
- Please keep the distance between implanted medical devices (pacemakers, cochlear implants, etc.) and wireless
- chargers >20CM to avoid potential interference with medical devices.
- Children should be supervised to ensure that they do not play with the wireless charger as a toy to avoid unnecessary accidents.
- If you need to clean the charger, please make sure it is disconnected from the power supply.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(l) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to parts of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation. lathis equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures·
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help FCC RF exposure statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance20Cm between the radiator &your body.
Customer Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>