SHARPER IMAGE MXW2024B27 Toy RC Monster Spinning Car Instruction Manual
- July 9, 2024
- Sharper Image
Table of Contents
SHARPER IMAGE MXW2024B27 Toy RC Monster Spinning Car Instruction Manual
Carefully remove items from package.
Locate the battery compartment on the back of each item. Swivel latches on bottom of car to release battery pack and insert batteries. Insert 4 AA 1.5V alkaline batteries (not included) for car and one 9V battery Into included for remote control.
Switch both car and remote buttons to “ON” position For best result use the car on hard surfaces such as wood or tile.
SAFETY PRECAUTIONS
- Do not operate during thunderstorms or rain.
- Avoid water, sand and snow when operating car.
- Do not submerge car or controller in water.
- Never operate your car on the street or highway.
- Never operate your car in a confined or crowded area, and do not use people or animals as obstacles.
- Do not run your car into furniture, objects or hard surface, as this will cause damage to both the objects and your car.
- Keep fingers, hair and loose clothing away from the tires, gears and motor while the car is switched to “ON”.
- Do not leave car or remote control near source of heat or under direct sunlight for long periods of time.
- Do not leave car or remote control outside overnight. Dampness is harmful to interior components.
- Remove all batteries when not in use to avoid accidental operation.
- Adult supervision is recommended when operating this car.
BATTERY WARNING:
-
Do not mix old and new batteries.
-
Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
-
Insert batteries using the correct polarity.
Do not short-circuit the supply terminal. -
Remove batteries when not in use. Recycle or dispose of exhausted batteries according to federal, state, and local laws.
Do not dispose of batteries in a fire they may leak or explode. • Only use manufacture specified battery(is), charger(s) and/or adapter, if applicable, specified by the manufacturer. -
Always use, replace, and recharge (if applicable) batteries under adult supervision.
-
Keep these instructions for future reference.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The artwork and design of this manual are protected by US copyright law and
may not be reproduced, distributed, displaced, published or used for any
purpose without prior written permission. Altering, removing or reproducing
any of the trademark or copyright notices on this package is not permitted.
Sharper Image name and logo (including the 77 logo and Tomorrow’s Tomorrow)
are trademarks or registered trademarks. Distributed by and 2019 Merch Source.
LLC. Irvine, CA 92618. All rights reserved.
Model Number: 1015647
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE
REFERENCE.
Due to continuous product improvements, the pictures on this manual may differ
slightly from the actual product.
FOR CUSTOMER SUPPORT, PLEASE CALL
1-800-374-2744