MAGICSHINE EVO 1700 Underneath Mounted Bike Light User Manual
- July 8, 2024
- MAGICSHINE
Table of Contents
MAGICSHINE EVO 1700 Underneath Mounted Bike Light
WARNING
- To prevent inadvertent switching on, please keep the light unit in lockout mode before transport or storage.
- DO NOT disassemble, modify, remanufacture, puncture, or damage the device or batteries.
IN THE BOX
OPERATING INSTRUCTIONS
HEADLIGHT BUTTON OPERATION
- ON/OFF: Press and hold the button for 1 second ADJUST BRIGHTNESS: When the light is on, click the button to change the brightness level. The output brightness will cycle through LOW→MEDIUM→HIGH.
- CHANGE MODE: Double-click the button to change between the low beam and the high beam. (Note: The Day flash and Night flash can only be accessed through the remote control.)
- CHECK BATTERY LEVEL: Click the button LOCK/UNLOCK: When the light is off, press and hold the button for 3 seconds to enter lockout mode. To unlock the light, you can press and hold the button again for 3 seconds or charge the light.
REMOTE CONTROL INSTRUCTIONS
Note
- Before first use, please open the remote’s battery compartment, remove the insulating spacer, reinsert the battery, then cover the battery compartment, and the indicator on the remote will flash blue.
- The remote control will enter sleep mode if the light is turned off for more than 48 hours without any operation. Click the light’s button to activate it or long-press the light’s button to turn it on, and the remote control can work normally.
REMOTE CONTROL PAIRING
- Turn on the light, press and hold the “○””□” buttons on the remote for about 10 seconds until the indicator alternately flashes blue to enter pairing mode.
- Then, put the remote close to the light button until the indicators on the remote and light unit are constantly blue for 2 seconds, confirming a successful pairing.
REMOTE CONTROL OPERATION
- ON/OFF: Press and hold the “○”/”□” button for 1 second
- ADJUST BRIGHTNESS: Click the “○” button
- CHANGE MODE: Double-click the “○” button
- FLASH MODE: Double-click the “□” button
- FULL OUTPUT MODE (1700LM): Click the “□” button to go into full output mode and click the “○”/”□” button to return to the previous mode.
CHARGING / BATTERY INDICATOR
- Standard charging time approx. 5 hrs (5V 1A)
- Charging: Flashing red
- Fully charged: Constant green
BATTERY INDICATOR
When the light is off, click the button to display the remaining battery level for 3 seconds.
- 100%-21%: Constant green
- 20%-11%: Constant red
- 10%-1%: Flashing red
OUTPUT / RUNTIME
- All data are measured under ANSI/NEMA FL 1-2009. The test was conducted at a temperature of 25°C and a wind speed of 25 km/h.
- The runtime may vary depending on external temperature and ventilation conditions, and these deviations may affect the result of testing.
HOW TO INSTALL / REMOVE
- INSTALL THE OUT-FRONT MOUNT
- REMOVE THE OUT-FRONT MOUNT
- REMOTE CONTROL MOUNTING
- Adhesive velcro hook side up
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>