Darkglass EN60555-2 Harmonic Booster Clean Bass Preamp Instruction Manual

July 6, 2024
DARKGLASS

Darkglass-logo

Darkglass EN60555-2 Harmonic Booster Clean Bass Preamp

Darkglass-EN60555-2-Harmonic-Booster-Clean-Bass-Preamp-
product

Specifications

  • Input Impedance: 470k
  • Output Impedance : 1k
  • Current Consumption: 30mA
  • Voltage: 9V DC (Center Negative)

Product Information
The Harmonic Booster Manual is part of the Enhancer Series by Creations Dealers Suite Apparel. It features various controls including Boost, Character, Mid gain, Mid Frequency, Bass, and Treble to shape the tone according to your preferences.

Dimensions

  • Width : 75 mm / 2.95″
  • Length : 111 mm / 4.37″
  • Height : 43 mm / 1.69″
  • Weight : 250 g / 0.55 lb

Product Usage Instructions

  1. Connect a regulated 9V DC adapter with a center-negative plug to power the Harmonic Booster.
  2. Adjust the Boost control to cut or boost the signal by up to 20dB.
  3. Use the Character control to blend in the tone-shaping circuitry for desired tonal characteristics.
  4. Set the Mid gain and select the frequency with the Mid Frequency control to shape the midrange frequencies.
  5. Adjust the Bass and Treble controls to boost or cut frequencies at 80 Hz and 5 kHz respectively.

Specs

Controls

  • Boost Flat -20dBto +20dBcut or boost.
  • Character : Allows blending in the perfect amount of the tone-shaping circuitry. It can be set counter-clockwise for a flatter frequency response.
  • Mid gain: +-20dB @ the frequency selected by “Mid

Frequency”.

  • Mid Frequency : Mid frequency from 250Hz to 2.5kHz.
  • Bass: +-20dB @ 80 Hz.
  • Treble: +-20dB @ 5 kHz.

Technical Specifications

  • Input Impedance : 470kΩ
  • Output Impedance :1kΩ
  • Current Consumption: 30mA
  • Voltag e: 9V DC (Center Negative)

Dimensions

  • Width : 75 mm / 2,95″
  • Length :111 mm/ 4,37″
  • Height : 43 mm / 1,69″
  • Weight : 250 g / 0,55 lb

Warning
The Harmonic Booster has a current draw of 30mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may resultin suboptimal noise performance and even damage your unit, voiding the warranty.

Warranty

To activate the warranty, we encourage you to register your product at: http://mypedal.darkglass.com and enter the serial number on the back of your pedal. Please contact us via email support@darkglass.com before shipping a product to us.

Disclaimer
In the interest of continuous improvement, specifications are subject to change without notice. If you have any questions, please don’t hesitate to contact us at www.darkglass.com The manufacturer claims that the above product fulfils the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE. 1176®, and SSL® are registered trademarks of their respective companies. Names of factory modes are intended for descriptive purposes only and should not be construed as an endorsement or affiliation with the companies or products named

EMC / EMI

This equipment has been tested and found to comply with the limits for a ClassB Digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee thatinterference will not occur in a particular installation.

If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more ofthe following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

https://www.darkglass.com/manual-harmonic-booster/

FAQ

Q: What power adapter should I use with the Harmonic Booster?
A: Use a regulated 9V DC adapter with a center-negative plug to power the Harmonic Booster. Avoid unregulated power supplies or higher voltages to prevent noise performance issues and damage to the unit.

Q: How can I activate the warranty for my Harmonic Booster?
A: Register your product on http://mypedal.darkglass.com and enter the serial number located on the back of your pedal. Contact support@darkglass.com before shipping any product for warranty service.

Q: Can I adjust the midrange frequencies on the Harmonic Booster?
A: Yes, you can adjust the midrange frequencies from 250Hz to 2.5kHz using the Mid Frequency control and shape them further with the Mid gain control.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

DARKGLASS User Manuals

Related Manuals