FORM DESIGNS AUSTRALIA IVI001 Video Conferencing Device User Guide
- July 4, 2024
- FORM DESIGNS AUSTRALIA
Table of Contents
FORM DESIGNS AUSTRALIA IVI001 Video Conferencing Device
VIDEO CONFERENCING DEVICE
The Video Conferencing Device has been designed to provide an eye-to-eye video conferencing experience. The Camera is located behind the mirrored glass which reflects the screen on the bottom. This provides the experience of looking at the person on the screen whilst also looking directly into the camera behind the glass.
CAMERA UNIT
The Camera unit is a top part of the Media unit.
- CAMERA
- LED STRIP
SCREEN UNIT
The Screen unit is a bottom part of the Media unit.
- LCD SCREEN
- LED STRIPS
- MICROPHONES X 4
STAND UNIT
The Stand unit is the base of the device which controls the device.
- РСВ
- SPEAKERS
- POWER BUTTON
- CONTROL BUTTONS
- CABLE (LINKS TO MEDIA UNIT)
PHONE HOLDER
This unit is an accesory that can be mounted on the main device.
- PCB
- CHARGING COIL
- USB C CHARGING PORT
BACK OF THE STAND UNIT
- DC POWER CONNECTOR
- XLR MICROPHONE PORT
- HDMI PORT X 2 (IN/OUT)
- STANDARD USB PORT
- USB C PORTS X 2 (IN/OUT)
- HEADPHONE AUDIO
POWER / ON BUTTON
Tower Bie in powered inside to indicate he idlie luated in and turns on/of
with the Power Button.
The POWER BUTTON FUNCTIONS:
- QUICK ONE PRESS – POWER ON
- LONG (3 SEC) PRESS – POWER OFF
- QUICK PRESS ON INCOMING CALL – VIDEO CALL STARTS
LED: DESK / FACE LIGHT
2 (two) LED strips are located on the Media unit; one under the Screen
Housing to be used as a desk light, and one on top of the Camera Housing which
is used as a face light.
- Top Light ON: only when screen is down (open) + the video call/conference is active.
- Bottom Light ON: when screen is up (closed).
CONTROL BUTTONS
On the right side of the device there are 2 (two) control buttons.
On the left side of the device there are 3 (three) control buttons.
WIRELESS PHONE CHARGING
The Phone Holder has a wireless phone charging function which can be mounted on the device and powered with a cable.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>