Birdfy Launch Various Feeder User Manual

: July 2, 2024
: Birdfy

Table of Contents

Birdfy Launch Various Feeder
FCC
What’s in the Box
Inserting MicroSD Card
Camera Charging
Turning the Camera On & Off
Pre-Installation Notes
Al Bird Identification
CONTACT US AT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Birdfy Launch Various Feeder

FCC

Warning
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications made without explicit approval from the responsible party in compliance may result in the user being unauthorized to operate the device. This device meets the FCC radiation exposure limits for uncontrolled environments. To ensure safe installation and operation, maintain a minimum distance of 20cm between the radiator and your body.

FCC ID: 2A08RNl-8111

CE Statement

The information provided on the packaging is allowed to identify geographical areas within the member states where restrictions on use or requirements for authorized use exist, if applicable.
The structure of the product allows it to be used in at least one member state without violating applicable requirements for the use of radio spectrum.

Manufacturer information:

NETVUE INC.
1055 East Colorado Boulevard 5th Floor
Pasadena, CA, 91106

What’s in the Box

Please note that if you have purchased the no-solar bundle, the package will not include a solar panel.

Inserting MicroSD Card

Birdfy Feeder comes with a built-in card slot that supports Class 10 microSD cards with capacities of up to 128GB.

Step 1: Rotate the camera downwards.
Step 2: Open the silicone cover and insert the microSD card. Make sure it is properly positioned with the label facing upward.
Step 3: Put back the silicone cover.

Camera Charging

The camera does not come fully charged due to safety regulations. Before using it for the first time, please charge it for 14 hours with the charging cable inside the box (DCSV / 1A).

The status light is solid yellow: charging
The status light is solid green: fully charged

Turning the Camera On & Off

Powering on or off: Long press the power button at the top of the camera.

Pre-Installation Notes

Keep Birdfy Feeder and all accessories out of the reach of children and pets.
Make sure the camera is fully charged (DC5V / 1A).
Working temperature: -10’C to 50’C (14’F to 122’F)
Working relative humidity: 0-95%
Please avoid exposing the camera lens to direct sunlight.
The camera has an IP65 waterproof rating, which allows it to function properly in rainy or snowy conditions. However, it should not be submerged in water .

Note:

Birdfy Feeder only works with 2.4GHz Wi-Fi.
Strong light may interfere with the device’s ability to scan QR codes.
Avoid placing the device behind furniture or near a microwave oven. Please try to keep it in the range of your Wi-Fi signal.

Al Bird Identification

If you bought the Birdfy Feeder Al, this feature is included and activated automatically, without any additional cost.
If you have the Birdfy Feeder Lite, you need to subscribe to access this feature.
With Al Bird Identification, you can find out in real-time which bird species are visiting your feeder.

Learn more at www.birdfy.com.