SUN2SOLAR 902518A Solar Heater Bypass Kit Instruction Manual
- June 27, 2024
- SUN2SOLAR
Table of Contents
SOLAR HEATER BYPASS KIT
for Connecting Multiple Units
INSTRUCTIONS
-
Turn off filter/pump then block off water from the pool at filter/pump and pool return connections.
-
Disconnect pool return hose from the filter/oump.
-
To install bypass kit:
a. Apply Teflon tape to the threading and then thread bypass fittings into the bypass valve.
b. Connect solar heaters as shown in figure using included hoses and hose clamps.
Hint: Using caution, dip ends of flex hose in hot water (not boiling) to help fit “T” connector. -
Unlock water and turn on filter/pump.
-
Adjust bypass valve as needed to achieve desired flow.
Bypass Kit Includes
1 – Bypass Valve
1- “T” Connector
3-14″/1/2″ Threaded Bypass Fittings
1-1½” x 72″ Flex Hose
6 – Stainless Steel Hose Clamps
1 – Teflon Tape
Bypass Valve Control
#902518A