Lume cube LC-AC1 CUBE STROBE Anti-Collision Light Instruction Manual
- June 3, 2024
- Lume cube
Table of Contents
Lume cube LC-AC1 CUBE STROBE Anti-Collision Light Instruction Manual
3 Strobe Light Functions
TESTING YOUR BATTERY
Pressing for 1 second will give you a 2-Flash confirmation that your strobe is
working and has battery. If there is no flash, this means your Strobe needs to
be charged.
-
Height Strobe Mode
-
TURN ON: Press down for 3 seconds
-
TURN OFF: Press down for 3 seconds
-
Low Strobe Mode
-
TURN ON: Press down for 3 seconds (activating High Strobe) then press once more for 1 second (activating Low Strobe)
-
TURN OFF: Press down for 3 seconds
-
Continuouse Mode (Always On)
-
TURN ON: Press down for 3 seconds (activating High Strobe) then press once more for 1 second (activating Low Strobe) then press a second time for 1 second (activating Continuous Mode).
-
TURN OFF: Press down for 3 seconds
GETTING STARTED
Attach 3M VELCRO
Included is your 3M” Dual Lock” velcro to mount your Strobe to your drone. Any side can be mounted to your Strobe.
-
Peel off the 3W protective film and stick your Velcro to your Strobe (figure 1)
-
Peel off the 3W protective film from the other side (figure 2) and stick that anywhere on your drone that you’d like your Strobe to be placed.
NOTE: Be sure to place where the propellers will not hit the Anti- Collision Strobe.
Charging
- Micro USB charging port
- Approximate Charge Time +/- 60 minutes
- When plugged in Strobe will flash while charging
- Flashing will stop when fully charged.
Color Cap Mounting
- Locate the micro USB port on your Strobe. Now, on the back end of the color cap, locate the cutout. Place the cutout over the micro USB port (figure 1) and bring the front end of the cap down over the Strobe until it snaps into place (figure 2).
SUPPORT & ACCESSORIES
Email customer service with any product-related issues or questions: support@lumecube.com. If you’d like to explore accessories for your Strobe or other drone-related products, visit: LUMECUBE.COM/DRONE.