Lume Cube Ring Light Mini User Guide

June 8, 2024
Lume cube

Lume Cube Ring Light Mini

Set up

  • Turn the lower Light Connection Tension Knob on the light stand counterclockwise to allow connection of the Ring Light. Once connected, turn the Light Connection Tension Knob clock-wise to secure. Do not over tighten Light Con-nection Tension Knob.
  • Use the upper Tilt Tension Knob on the light stand. Turn counterclockwise to loosen, adjust to desired tilt, then turn clockwise to tighten

Control

  • Press Control Dial down to toggle through 3 modes: Brightness Level, Color Temperature and Battery Status.
  • In Brightness Control mode, the LED indicator will read “BRT” Turn dial to adjust brightness level from low (p-00) to high (p-100).
  • In Color Temperature Mode, the LED indicator will read “CCT”. Turn dial to adjust color temperature from cool to warm ( 3200 – 5600K ).
  • In Battery Power mode, the LED indicator will read “FULL” when batteries are fully charged or display a range from low (E-00) to high (E-10) for all other levels. When using AC Power supply, the indicator will read “FULL”.

Power Option

Battery Operation

  • The Ring Light will only operate on DC power when battery is charged and connected to the light.
  • Ensure the Ring Light is OFF by moving power switch to the middle position [0].
  • Align the battery connection points with connection points on the Ring Light.
  • Gently slide the battery outwards until the connection is secure. Repeat process for second battery.
  • Press the [I] side of the power switch when using DC power supply to power ON.

Power Cord Operation

  • Ensure the Ring Light is OFF by moving power switch to the middle position [0].
  • Insert power cord into standard wall outlet.
  • Insert AC power supply cord into AC receptacle on the back of the Ring Light.
  • Press the [II] side of the power switch when using AC power supply to power ON.

Warning

  • Only use with the included AC power supply and power cord.
  • Only use with NP-F Series batteries of the same capacity (Voltage Range: 7.4V-12V).
  • Both batteries should have the same state of charge when mounted. Avoid using a fully-charged battery and a partially depleted battery at the same time.
  • Always remove batteries during storage and/or transport to avoid accidental operation which may lead to overheating if in the travel case.
  • Keep away from fire and water.
  • Do not submerge in water.
  • Do not force electrical connections.
  • Do not over tighten the mounting and/or tilting knob.
  • Do not over tighten accessories to the mounting thread or cold shoes.
  • Do not attempt to open or modify Ring Light.

Ring Light Mini

Lume-Cube-Ring-Light-Mini-FIG-1

Inside The Box

Lume-Cube-Ring-Light-Mini-FIG-2

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals