JAMARA 460623 Ride-On Lamborghini Urus Kids Car Instructions

Ride-on
Lamborghini Urus

No. 460623 yellow
No. 460624 white-
Instruction

General information

JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.

Suitable for children over 3 years.
Warning: Not suitable for children under 36 months. RISK OF SUFFOCATION!
Contains small parts which can be swallowed. Keep away necessarily from children
Due to its top speed this toy is not suitable for children under 3 years!

• Before playing, remove all protective films from all parts
• This product is not intended for use by individuals (including children) with reduced physical, sensory or mental capabilities or lack of experience and / or knowledge.
• Depending on development, a minimum age of 4 years could be appropriate
• Maximum weight: < 28 kg Before assembly
• Adult required for assembly. Keep children away while assembling.
• Tools (not included) needed for assembly: screwdriver.

Certificate of Conformity
Hereby JAMARA e.K. declares that the products „Ride-on Lamborghini Urus, No. 460623, No. 460624“ comply with Directives 2014/35/EU, 2014/53/EU, 2011/65/EU and 2009/48/EC.
The full text of the EU Declaration of Conformity is available at the following Internet address: www.jamara-shop.com/Conformity

|  Read the complete instructions and security instructions carefully before using the   model.
---|---
|  To prevent accidents and injuries, DO NOT leave your Child unattended during operation of the vehicle. Never let your Child out of your sight while the driving a vehicle .
| DO NOT use the vehicle on public roads or places or other dangerous locations.
ONLY operate the Ride On Car in places such as private parking, private land or other safe locations. Make sure that no person or animal is endangered.
| The model stops after releasing the accelerator, independently on a horizontal surface. The vehicle has no brake or parking brake. Do not operate the vehicle uphill or downhill, and secure it when parking.

  DANGER

• For safe driving, you should make sure that your Child understand and adheres to the following rules:
  – Always sit tight, do not get up during the ride.
  – Never take additional Children for a ride. (The vehicle is only suitable for 1 person)
  – Hold tight.
  – Never drive without shoes.
  – Never drive in the dark.
  – To be used with protective equipment.

• Keep hands, hair, loose clothing and any other item away from any rotating parts.

• The Model should not be used in rooms or halls with high humidity, in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.

• The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil.

Attention!
Keep the not mounted kit away from small children as it contains swallowable parts.
It must be assembled or checked by adult to make sure the car is assembled on the right way before playing.

Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.

Box content:

• Model
• Transmitter 2,4 GHz
• Battery pack (412620)
• Charger 230 V (412978)
• Assembly tool
• Instructions

Parts

A| Steering wheel| | I| Seat|
---|---|---|---|---|---
B| Instruction| | J| Gearbox right|
C| Rearview mirror| | K| Gearbox left|
D| Wheel connector| | L| Screws|
E| Remote control| | M| Assembly tool|
F| Windshield| | N| Charger|
G| Wheels| | O| Nut|
H| Wheel caps| | P| Washer|

– If the transmitter and the charger not loose in the carton, it is iattache in the vehicle body. Please take them out before installing the seat.

1. Remove the nut and washer from the rear axle
   Loosen the nut (O) and washer (P) from the rear axle. Remove the paper protector (4) and throw it in the rubbish.

2. Motor assembly
   Slide the two motors (J, K) onto the rear axle and run the cables through the hole in the model.
   The motors are marked with R and L. Make sure you insert the motors on the correct side.
   Finally, put the two wheel connectors (D) on the motors.

3. Remove the nut and washer from the front axle
   Loosen the nut (O) and washer (P) from the front axle.

4. Mounting the wheels
   Now push the wheels (G) onto the rear axle. First place the washer (P) underneath and then fasten the whole thing with a nut (O). Finally, attach a hub cap (H). Press the hub caps (H) into the recesses provided in the wheel until they click into place. Repeat this procedure for the front axle.

5. Mounting the steering wheel
   Connect the cable from the steering wheel (A) to the cable of the model. Test the horn and the music button to make sure the connection works. Squeeze the steering wheel socket (1) slightly and slide the whole thing into the holder provided in the model.

6. Fitting the windscreen
   Press the windscreen (F) into position until it clicks into place.

7. Battery connection
   Connect all connectors as shown. Only connect wires that fit together and be careful not to reverse the polarity. Check the power supply by pressing the ON/OFF switch on the model.
   If the power supply is working, you will hear a motor noise.

8. Assembling the seat
   Position the seat (I), making sure that the pins on the seat engage with the holes in the body.
   When the position is correct, secure the seat with screws (L).

9. Fitting the rear-view mirror
   Press the rear view mirrors into position until they click into place.

10. Charging your vehicle
    • The power swich must be turned in OFF position when charging.
    • Insert the charger into the socket – the LED lights up green. Connect the charger to the charging socket.
    • The LED on your charger lights up red as long as the battery is being charged. If the LED lights green again, the battery is fully charged.
    • The charge time is 9 hours.
    • Do not charge the battery more than once within 24 hours.
    • Charger and battery heat up during the charging process.

Attention!

• The charger is not a toy. Only use the charger supplied.

• The battery may only be charged by or under the supervision of an adult.

• The terminals must not be short-circuited.

• The charger must be checked regularly for damage to the cable, plug, housing and other parts. If any damage is found, the charger must not be used until the damage has been repaired.

• Let the model cool off sufficiently after each use before putting it back into operation.
  When using an additional batteries let it cool off for minimum 15 minutes until the model is operated again. Overheating can damage the electronics or may result in fire.

• Always disconnect the model from the charger immediately after charging. Always disconnect the charger from the power supply immediately after disconnecting the
  model. Inserting the rechargeable model or charger after charging will result in damage to the model, charger or the power supply (fire hazard).

• Use the charger only in dry rooms.

Functions

1. ON/OFF Switch
   With the ON/OFF switch you start the vehicle.

2. Light button

3. Music

4. Horn

5. Forward▲:
   Press the shift lever on the „Forward ▲“ position.
   Press the foot pedal, the model drives forward.
   Reverse▼:
   Press the shift lever on the „Backward▼“ position.
   Press the foot pedal, the model drives backwards.
   Important!
   The vehicle must be stationary before changing direction. Otherwise the gear unit and/or the motor could be damaged.

6. Soundboard
   A Voltage disply
   Attention!
   Your vehicle displays the total voltage of the two batteries in volts immediately after switching on. The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts unloaded. The display is load dependent. This means that the displayed voltage will drop under load. If a voltage of less than approx. 11.8V is displayed in the unloaded state, you should switch off the Ride-on and charge the battery (see charging procedure). Otherwise the battery may be deeply discharged and irretrievably damaged. Otherwise, the battery may become deeply discharged and be irretrievably destroyed. A deeply discharged battery is not covered by the warranty and must be replaced at a charge.
   B USB
   C V
   Press = previous, long press = Volume down
   D Story/pause & play
   E Musik/V+
   Press = Next, long press = Volume up
   F Song button
   G Aux
   Connect MP3 device / mobile.
   H Micro SD

Functions transmitter

1. Forward
2. Backward
3. Speed
4. Emergency brake
5. Left
6. Right
7. LED Indicator
8. Battery compartment

Fitting the batteries
Observe the polarity..

Battery warning:
Non-rechargeable batteries are not to be recharged!
Do not open! Do not dispose of in fire!
Do not mix old and new batteries!
Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
Rechargeable batteries are to be removed from the toy before being charged!
Rechargeable batteries are only to be charged under adult supervision!
The supply terminals are not to be short-circuited!

Binding transmitter and model
Switch off the model. Insert 2 AAA batteries into the transmitter. The LED indicator on the transmitter will start flashing. Now switch on the model. Press the button with the label „P“ (4). After successful binding the LED display stops flashing and two LEDs should light continuously. Press the button labeled „S“ (3) to make the vehicle ready to drive. The transmitter is now bound and only needs to be bound again when the battery is changed. If the transmitter is not used for a longer period of time, it will go into standby mode. The LED display will go out. To release the transmitter from standby mode, press any button on the transmitter.

Caution
Always switch off the model immediately after each use. Immediately after each use the battery should be disconnected from the model. The battery can be deeply discharged by leaving it switched on accidentally or leaving it plugged in. Deep discharge causes the battery to lose power or can be damaged to such an extent that charging or discharging is no longer possible or the battery can self-ignite during charging or discharging (fire hazard). Never attempt to charge or discharge deeply discharged batteries. The battery voltage should never fall below 11,9 volts to avoid deep discharge. The fully charged battery has a voltage of approx. 13 Volt. After use, the intact battery should be fully charged immediately after a cooling phase of at least 10 minutes but at the latest after 12 hours to avoid subsequent deep discharge by self- discharge. If the battery is not used or stored for a longer period of time, the battery should be checked for voltage (min. 12,3 volts) or damage at least every 3 months and charged or disposed of if necessary.

charger and battery
The battery can no longer be charged although the battery and charger are OK.| Charging socket defective (if present)| Check or replace the charging socket.
The journey time is very short.| The battery has been deep discharged or is worn out.| Use a new battery and avoid deep discharge.
No function| Battery is not or incorrectly connected.| Connect the battery (see instructions)
ON/OFF switch defective.| Check or replace switch.
Can be switched on but does not drive.| Motor cable incorrectly connected or not connected.| Check and connect motor cable (see instructions).
Can be switched on but does notmove, or only direction.| Gas or direction switch defective.| Check or replace switch.
Can be switched on but only travels in one direction.| Directional switch defective.| Check or replace switch.
The active fuse blows and switches the unit off for a few seconds. You will hear a single click at the beginning| Oberload or electrical short circuit.| Do not overload or have the until checked.
Vehicle does not respond to remote control| Not bound.| Carry out the binding process (see instructions).
No sound function on the steering wheel/andlebar| the cable was torn or crushed during assembly.| Check or replace the steering wheel.
Vehicle has very high wear on switches.| Dirt and moisture damage the switches.| Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
The rubber tyres come loose on the wheels| Ridden on too hot a surface or in dirt.| Change tyres and avoid hot surfaces and dirt.
Wheel keeps falling off the axle.| Mounted incorrectly.| Check that the wheel is properly engaged (see instructions).

– You can find further solutions to problems on the Internet in our FAQ at: https://jamara-shop.com/FAQ

Spare parts

| No. 412620 12V 4,5Ah
Battery| | No. 413295
Transmitter
---|---|---|---
| No. 413166
Light switch| | No. 413298
Front wheel
| No. 413294
Gearbox right| | No. 413301
Steering wheel
| No. 413297
On/Off switch| | No. 412978 12V 1000mAh
Charger
| No. 413300
Exterior mirror| | No. 413293
Gearbox left
| No. 413304
Rear wheel axle| | No. 413296
Receiver electronics
| No. 412866
Switch forward/backward| | No. 413299
Rear wheel
| No. 413292
Soundboard| | No. 413302
Windshield

Disposal restrictions

Batteries and accumulators must not be disposed of in domestic waste. You are obliged to dispose of batteries (seperate collection) appropriately. After use you can return batteries free of charge to the retail store. As batteries contain substances that can be irritant, can cause allergy and are highly reactive, separate collections and proper recycling is important to the environment and to your health. If the batteries are marked with a chemical symbol Hg, Cd or Pb below the crossed-out waste bin on wheels it refers to that more than 0.0005% of mercury (Hg), more than 0.002% of cadmium (Cd) or more than 0.004% Lead (Pb) is included.

All rights reserved. Copyright JAMARA e.K. 2022
Copying or reproduction in whole or part, only with the expressed permission of JAMARA e.K.

Service centre
JAMARA e.K.
Inh. Manuel Natterer
Am Lauerbühl 5 – DE-88317 Aichstetten
Tel. +49 (0) 75 65/94 12-0 – Fax +49 (0) 75 65/94 12-23
info@jamara.com ● www.jamara.com
Service – Tel. +49 (0) 75 65/94 12-777
service@jamara.com

References

• jamara.com
• Naslovnica - Net.hr
• jamara.com
• Janus Trade
• Reitter Modellbau & Robotics - Zubehör, Ersatzteile, Bausätze
• FAQ - Fragen und Antworten

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>