HOOVER HDG6C1GBTK Cooker Hood User Manual

HOOVER HDG6C1GBTK Cooker Hood

PLEASE READ THIS GUIDE FIRST!

Dear Customer, We would like to offer you the best yield for your product which is produced in modern facilities and passed through strict quality control. For this, please read this manual thoroughly before using your product and keep it as a reference.

THIS MANUAL
It helps you to use your product quickly and safely.

• Read the user manual before using and operating the product.
• Particularly follow safety information.
• Keep it in a place where you can easily Access the user guide as you may need it later.
• Also read the additional documentation supplied with the product. Please note this manual may also apply to other models. The differences between the models are clearly highligted in the guide.

CONTENTS

• Security alerts
• Product introduction and technical information
• Product montage
• Product usage
• Maintenance and cleaning
• Your contribution to protecting the environment

SECURITY ALERTS

• The operating voltage is 220-240 volts.
• You can use pipes with a diameter of 120mm or 150mm when you make a chimney connection to your hood.
• Do not make connections to the boiler where the boilers are connected, the boiler that the waste gasis poured into, or the flame rising boom.
• The height between the bottom surface of your hood and the top surface of the oven/oven should not be less than 65cm.
• Do not operate your hood without an aluminum filter.
• Do not remove aluminum filterwhilethe hood is operating.
• Do not touch these lamps after the lamps of your hood have been running for a long time. The heated lamps can burn your hood.
• Do not build a high flame under your hood. Otherwise, oil in the aluminum filter may ignite and cause fire.
• If cleaning is not carried out periodically, risk of burning mayocur in your hood.
• After putting pots or pans on the stoves, run the hood.
• In order to clean the kitchen air well from the smell and the cooking stove, run the hood for 15 minutes after cooking or frying is over.
• When the hood is in operation, especially when used together with gas cookers, ensure that fresh air enters the room.
• Keep away from children, as packaging materials can be dangerous.
• Do not wear a prize before your hood is assembled.
• Do not allow small children to use this product.
• This product is intended for use at home. Commercial use is not suitable and should not be used outside of its intended purpose.
• This product should not be used by persons with reduced physical, sensory or mental capabilities (including children) or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for the safety.
• Fats can catch fire when cooking fry etc. Therefore, pay attention to the covers and curtains.
• When cooking fries do not leave the top of your cooker, hot oil may cause fire.
• Cut off the electrical connection of the product before any intervention in the interior.
• We advise you to be very careful when handling the interior of the hood and use gloves.
• We recommend that you start the product a few minutes before starting the cooking process to increase traction. In this way, when the vapors start to form, you will get continuous and constant traction.
• If there is another product operating with energy other than electrical energy in the same environment with the hood, the negative pressure in the room should be at most 0.4 mbar so that the waste gas from the chimney of the other product is not drawn back.
• Our company will not be responsible for problems caused by non-observance of the above warning.

PRODUCT INTRODUCTION AND TECHNICAL INFORMATION

PRODUCT INTRODUCTION AND TECHNICAL INFORMATION

PRODUCT INTRODUCTION AND TECHNICAL INFORMATION

PRODUCT MONTAGE

Product Location : The height between the bottom surface of your hood and the top surface ogle oven/ oven should not be less than 65 cm.

• Drilling the hanger holes : Stick the hanger sheet that came out of the product packaging on the surface where the hood will be hung and mark the surface through the holes in the sheet. Drill holes with an 8 mm drill from the marked points.
• Driving the dowels : To screw the hanging plate, drive the 1 O mm dowels that came out of the mounting package into the drilled holes.
• Screwing the hanger plate : Screw the hanger plate to the dowels you have driven with the screws from the assembly package.
• Hanging the hood on the wall : Hang the product on the hanger sheet you have fixed on the wall.
• Screwing the flue hanger plate : Screw the hanger plate to the dowels you have driven with the screws from the assembly package.
• Attaching the flue plate : Put the flues around the body and screw them with the screws from the assembly package to fix it.
• Aluminum pipe fitting: One end of the aluminum pipe is the plastic bacquet on the product; And the other end to the kitchen sink. Make sure that these two connectors are tight enough that they will not come out of place when the hood is operating at the highest speed. The diameter of plastic bacan on the product is 150 mm. If aluminum pipe with a diameter of 120 mm is to be used, it is necessary to install a plastic reducer from the packaging.

OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.

1. ON/OFF : Pressing the button during the functioning, the hood turns OFF
2. SPEED SELECTION: Pressing button I, II or Ill the hood passes from the OFF state to selected speed. Speed selection increased from I to Ill…
3. ILLUMINATION: You can turn on/off the illumination/lighting pressing this button
4. TIMER : Pressing speed buttons for a while, the hood will run for 15 minutes and will stop automatically after this time.

1. ON/OFF : Pressing the button during the functioning, the hood turns OFF
2. SPEED SELECTION: Pressing button I, II or Ill the hood passes from the OFF state to selected speed. Speed selection increased from I to Ill. ..
3. ILLUMINATION: You can turn on/off the illumination/lighting pressing this button

MAINTENANCE AND CLEANING
Before maintenance and cleaning, remove the product plug from the socket, or switch off the switch or loosen the fuse that feeds the hood, then switch it off. Clean the hood made of sheet and glass painted with static powder paint with cleaning materials specially designed fort his material.

Never use metal rubbing cloths and abrasive materials (brush, dishwasher hard side, etc.).
Dry your hood with a lint-free cloth.

Aluminum Filter
This filter helps keep the oil particles in the air. It is recommended that you clean your filter for 1 month in normal use. To do this, remove the aluminum filter first. Rinse the filters in water with liquid detergent and rinse them after drying. AS the aluminum filters are washed, the color change can be observed and this is normal. You do not need to change the filter.

Note: You can also wash your aluminum filters in the dishwasher.

Removal of Aluminum Filters

• Push the aluminum filter pillarforward.
• Then gently lower it down and pull it to the front.

ATTENTION!

• The oil filter is used to catch oil particles suspended in the air; Therefore it reaches saturation for a certain period of time (the saturation of the filter depends on the method of use product).
• After 4 months of use with carbon filter (without chimney), aluminum filters must be cleaned and carbon filters must be changed.

LED Replacing

REPLEACABLE (LED only)
LIGHT SOURCE BY A PROFESSIONAL

YOUR CONTRIBUTION TO PROTECTING THE ENVIRONMENT

Disposal Of Old Product
Discard the old product so as not damage the environment. Ask your dealer or your municipal garbage collection center about how to dispose of the product. Cut off the power plug for children’s safety and put your product out of operation before throwing away the product.

Disposal Of Packaging
Packaging metarials are dangerous for children. Keep packaging materials out of the reach of children. The product’s packaging is made from recyled material. Garbage by sorting according to the waste instructions. Do not thow away with normal household garbage.

This appliance is labelled in accordance with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment Regulations 2013 regarding electric and electronic appliances (WEEE). The WEEE contain both polluting substances (that can have a negative effect on the environment) and base elements (that can be reused). It is important that the WEEE undergo specific treatments to correctly remove and dispose of the pollutants and recover all the materials. Individuals can play an important role in ensuring that the WEEE do not become an environmental problem; it is essential to follow a few basic rules

• the WEEE should not be treated as domestic waste;
• the WEEE should be taken to dedicated collection areas managed bythetown council or a registered company.

In many countries, domestic collections may be available for large WEEEs. When you buy a new appliance, the old one can be returned to the vendor who must accept it free of charge as a one-off, as long as the appliance is of an equivalent type and has the same functions as the purchased appliance.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>