Renyqatt 2BGN4C31 LED Lamp Wireless Charger User Manual

LED Lamp Wireless Charger
User Manual

2BGN4C31 LED Lamp Wireless Charger

1. Watch Charging Area
2. Phone Cha Area
3. AirPods Charging Center| 4. Aluminum alloy panel
5. RGB Ambient Lamp
6. Indicator Lights
---|---

9. USB-C Power Socket
10. Bottom Label| 11. Non-slip Mat
12. Heat Vent
---|---

1. Power on
   

2. Put phone to hold magnetically to charge (support magesafe cases)
   

3. Put iWatch to hold magnetically to charge

4. Put earbuds on the centre to charge

Charge 3 Apple Devices Simultaneously

Touch Key to Switch Colorful RGB Lamps

• Touch key to cyclically switch verious RGB lamp modes to off mode
  

• Long touching can adjust bright-ness of white and warm light
  

Indicator Lights Instructions

FOD: if foreign object is detected, light will flash, charging will stop for satety

APPLICABLE DEVICES

1. Smanrt Phone: Apple: iPhone 12~15 full series.
   Indude other phones with magesafe charging receiver (meet Qi standard).

2. Smart Watch: Apple: iWatch S2~S8,SE 1~3,Ultra1/2

3. TWS Earbuds: Apple: AirPods 23, AirPods Pro 1/2
   Indude other earbuds with wireless charging receiver (meet Qi standard)

PRODUCT SPECIFICATION

Input 12V/2.5A
Watch Output: 2.5W
Input Socket. USB-C
Transmission Distance for Phone: 3~10mm
Product Size: 77.5 x 175 x 169 3mm
Phone Output 1SW/0W/7.5W/SW
Earbuds Output: 3. OW
Conversion Rate(Phone): > 75%

PACKING LIST

4 1N 1 Wireless Chager x1,
User Manual x 1

WARNING

1. Avoid using the product at places that are wet, hermetic or hot.
2. Avoid dropping the product from high places.
3. Do not disassemble the product by yOurselves.
4. Do not clean the product unless it is powered off.

Must use QC 3.0 or PD protocol adaptor(both 18W or above), and fast USB-C cable, if not, charging may be slow failed or even hurt devices.

FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>