OLIMEX ESP32-S3 LiPo Open Source Hardware Board Dev Kit User Manual

June 21, 2024
OLIMEX

**OLIMEX ESP32-S3 LiPo Open Source Hardware Board Dev Kit User Manual

**

Introduction to ESP32-S3-DevKit-LiPo

ESP32-S3 is a dual-core XTensa LX7 MCU, capable of running at 240 MHz. Apart from its 512 KB of internal SRAM, it also comes with integrated 2.4 GHz, 802.11 b/g/n Wi-Fi and Bluetooth 5 (LE) connectivity that provides long-range support. It has 45 programmable GPIOs and supports a rich set of peripherals. ESP32-S3 supports larger, high-speed octal SPI flash, and PSRAM with configurable data and instruction cache.

ESP32-S3-DevKit-LiPo board is development board with ESP32-S3 and these features:

  • ESP32-S3-WROOM-1-N8R8 8MB RAM 8 MB Flash
  • Green Status LED
  • Yellow Charge LED
  • UEXT connector (pUEXT 1.0 mm step connector)
  • USB-C power supply and USB-Serial programmer
  • USB-C OTG JTAG/Serial connector
  • LiPo charger
  • LiPo battery connector
  • External power sense
  • Battery measurement
  • Automatic power supply switch between USB and LiPo
  • RESET button
  • USER button
  • Dimensions 56×28 mm

Order codes for ESP32-S3-DevKit-Lipo and accessories:

ESP32-S3-DevKit-LiPo ESP32-S3 development board with USB JTAG/Debugger and Lipo charger
USB-CABLE-A-TO-C-1M USB-C power and programming cable
LiPo batteries
UEXT sensors and modules

HARDWARE

ESP32-S3-DevKit-LiPo layout:

Product Layout
Product Layout

ESP32-S3-DevKit-LiPo GPIOs:

GPIOs

POWER SUPPLY:

This board can be powered by:

+5V: EXT1.pin 21 can be input or output
USB-UART: USB-C connector
USB-OTG1: USB-C connector
LiPo battery

ESP32-S3-DevKit-Lipo schematics:

ESP32-S3-DevKit-LiPo latest schematic is on GitHub

UEXT connector:

UEXT connector stands for Universal EXTension connector and contain +3.3V, GND, I2C, SPI, UART signals.

UEXT connector can be in different shapes.

The original UEXT connector is 0.1” 2.54mm step boxed plastic connector. All signals are with 3.3V levels.

UEXT Connector

note it share same pins with EXT1 and EXT2

UEXT Connector

As the boards become smaller and smaller some smaller packages were introduced too beside the original UEXT connector

  • mUEXT is 1.27 mm step boxed header connector which is with same layout as UEXT
  • pUEXT is 1.0 mm single row connector (this is the connector used in RP2040-PICO30)

Olimex has developed number of MODULES with this connector. There are temperature, humidity, pressure, magnetic field, light sensors. Modules with LCDs, LED matrix, Relays, Bluetooth, Zigbee, WiFi, GSM, GPS, RFID, RTC, EKG, sensors and etc.

pUEXT signals:

pUEXT signals

SOFTWARE

Revision History

Revision 1.0 July 2023

olimex.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals