PAGERTEC Wear and Go Watch Paging System Installation Guide

PLUG & PLAY

HOW TO INSTALL A

WEAR AND GO WATCH

• Easy setup Set up your system in minutes

1. Plug Transmitter into power outlet
   

2. Plug USB Cable into outlet to charge.
   

3. Hold side button for 5 seconds to turn on.

NOTE: Charge watches for 24 hrs before using

DIAGRAM INSTALLING WEAR AND GO WATCH

1. Connect the two antennas to the top of transmitter
   After plugging in the antenna, twist it to the right.

2. Connect the adapter to the top right of transmitter

• THEN, PLUG IT IN TO A POWER OUTLET
  110V – 220V

  3. Turning watches on
     Plug power adapter into wall, then connect the usb power cable from the adapter to the watch.

HOW TO USE

• Write the Employee name next to his pager number with a dry erase marker.
• WARNING!! Regular ink will make permanent marks, making name changes difficult-clean with a non-abrasive cleaner ONLY!
• The name plates can easily be removed and replaced to simplyfi pager assignment.
• Press the number that corresponds the employee name on the sending unit and that pager will silently vibrate. Range of this system should easily cover even the largest of restaurants.

• For more information such as warranty, details and system manual please visit www.pagertec.com/support •

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>