ideal lux Circus SP D74 Circus LED Pendant Light Instruction Manual
- June 21, 2024
- ideal lux
Table of Contents
ideal lux Circus SP D74 Circus LED Pendant Light
Product Specifications
- Model: Circus SP D74
- Power: LED 36W
- Voltage: 220-240V, 50/60Hz
- Energy Efficiency Class: F
- Light Source: 900 mA, 36 V DC
- EAN: 8021696291406
Product Usage Instructions:
Installation:
- Ensure the installation is carried out by a qualified electrician.
- Follow the assembly instructions in numerical order as provided in the manual.
- Do not fix the light source yourself.
Replacing Light Source:
The light source is replaceable by an end-user. Follow these steps:
- Ensure the power is turned off before replacing the light source.
- Carefully remove the old light source and replace it with a compatible one.
- Dispose of the old light source properly according to local regulations.
Safety Instructions
Follow these safety guidelines while using the product:
- Always disconnect the power supply before installation or maintenance.
- Avoid looking directly at the light source.
- Use appropriate fixtures and accessories for mounting.
- If the external power cable is damaged, it should only be replaced by the manufacturer, retailer, or a qualified electrician.
- Do not disassemble the LED light source as it is non-replaceable.
****Suspension lamp
DIMENSION
FEATURED
LED 36W / 220~240V 50/60Hz- 8021696291406 NERO
INSTALLATION INSTRUCTION
FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION. THE LIGHTING FITTING SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN.
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
This product is provided with a light source with efficient energy class of:
- Light Source Mode: CIRCUS MODULE
- Energy Efficiency Class: F
- Light Source (mA): 900 mA
- Light Source (V): 36 V DC
LEGENDA ICONE
SAFETY INSTRUCTIONS
- This fitting is produced and tested by the strictest European safety standards (EN 60.598- 1).
- This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
- As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
- If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
- Always isolate power before commencing installation, maintenance or repair.
- The luminaire contains certain parts which can be very hot.
- Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
- Always tighten the screws firmly to avoid contact problems.
- This fitting should only be installed indoors.
- Luminaires are not suitable for recessed on normally flammable surfaces.
- Luminaire is not suitable for direct mounting on normal flammable surfaces.
- This fitting is only suitable for fixing the ceiling.
- This fitting is only suitable for fixing the wall.
- The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
- Only use lamps that do not exceed the maximum specified wattage.
- Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
- Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing them.
- Cracked or broken safety glass has to be replaced immediately. Use only manufacturer-approved parts complying with regulations.
- Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
- This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
- Class I Electrical safety is guaranteed by the main insulation and an additional protective conduct- tor (earthing) connected to the metal frame of the lamp. Earthing is obligatory.
- Class I| Electrical safety guaranteed by the main insulation and double or reinforced insulation. Earthing is not necessary.
- Class Ill Electrical safety is guaranteed by a very low power supply (less than 50 Volt). Earthing excluded
- Not Protected
- Protected against solid objects greater than 50 mm.
- Protected against solid objects greater than 12 mm.
- Protected against solid objects greater than 2,5 mm.
- Protected against solid objects greater than 1mm.
- Dust protected.
- Protected against dust infiltration.
- Not protected.
- Protected against vertically falling water drops.
- Protected against water drops falling with a maximum angle of 15° to the vertical axis.
- Protected against rain.
- Protected against splashing water.
- Protected against water jets.
- Protected against strong water jets.
- Protected against temporary immersion.
- Protected against prolonged immersion.
- Luminaire not suitable for covering with thermally insulating material.
- Caution, risk of electric shock.
- Do not stare at the operating light source.
MORE INFORMATION
IDEAL LUX s.r.l.
- Via Taglio Destro 32
- 30035 Mirano (VE) Italy
- www.ideal-lux.com
IDEAL LUX Warehouse
Via delle Industrie, 8/D
30036 Santa Maria di Sala (Venezia)
8.00 – 12.00 / 13.30 – 17.00
Frequently Asked Questions
- Q: Can I replace the LED light source myself?
- A: Yes, the LED light source is replaceable by an end-user. Make sure to follow safety precautions and use a compatible replacement.
- Q: What should I do if the external power cable is damaged?
- A: In case of damage to the external power cable, it should only be replaced by the manufacturer, retailer, or a qualified electrician to ensure safety.
- Q: Is it necessary to disconnect the power before installation?
- A: Yes, always disconnect the power supply before starting any installation or maintenance procedures to prevent accidents.