HOVERair X1 Pocket Sized Self Flying Camera Drone User Guide

Table of Contents

Scan the QR code to download and install the Hover X1 App from the official website.
Connect the USB cable to the HoverAir X1 and a USB power source for charging. The LEDs will blink during charging. When fullycharged, the LEDs will be always-on or always off.
Press and hold the power button for 2 seconds until you hear a voice prompt and see the status indicator light up in green.
Open up the HoverAir X1 and hold it flat in your palm. Press the mode button to select the flight mode, then press the power button to take off. Ensure propellers are spinning before removing your hand.
To land, grab the HoverAir X1 mid-flight and press the power button or flip it upside down to stop the propellers. Avoid inserting fingers near the propeller area.
Connect the HoverAir X1 to the Hover X1 App on your iOS or Android device for additional features and controls.

Q: How do I know when the battery is fully charged?
A: The LEDs will either be always on or always off when the battery is fully charged.
Q: Can I change flight modes during operation?
A: Yes, you can short-press the mode button to select different flight modes and long-press to adjust parameters within each mode.
Q: What should I do if the propellers do not stop spinning after landing?
A: If propellers do not stop spinning after landing, grab the HoverAir X1 and press the power button or flip it upside down to stop them.

Scan the QR code below to download and install the Hover X1 App.
This guide is subject to change without prior notice. Please visit our official website for user manual and other latest information.

Charge the battery

Press and hold the power button for 2 seconds until the voice prompt is heard, and the status indicator will light on in green.

Mode Selection and Takeoff

Open up the HoverAir X1 as shown below and hold it flat in your palm.
Short press the mode button (behind the power button) to select the flight mode of your choice. You can long press the mode button to toggle parameters for each flight mode.
Short press the power button to take off. Once the propellers have started spinning, remove your hand from under the device.

Grab the HoverAir X1 mid-flight and press the power button or flip it upside down 180 degrees to stop the propellers
At the end of the flight or during continuous flight modes, place your hand 20cm below the device and it will automatically land in your hand and the propellers will stop spinning

Caution

DO NOT stick fingers or anything else into the propeller area. Please refer to the safety instruction manual and disclaimer online for more information.

Open the Hover X1 App and enjoy flying HoverAir X1- Make sure your mobile device’s Bluetooth and WiFi are on.
Connecting to the device is managed entirely from the app, there is no need to connect to your Hover via your mobile device settings.
Open the Hover X1 app and select Hover-> “Click to activate/connect” .
You may be prompted to allow the app to access Bluetooth.
Now you can use the app to change flight mode settings To download your media, select the “Album” icon. You will be prompted to connect to your Hover over WiFi

Read User Manual Online (PDF format)