ADC 750W Wall Aneroids Sphygmomanometer Large Adult Installation Guide

ADC 750W Wall Aneroids Sphygmomanometer Large Adult

Tools Needed

• Medium Phillips head screwdriver
• Hammer
• Drill with 3/16” drill bit

Directions

1. Position manometer (with attached wall bracket) on wall at desired location and rotate gauge to right side to permit access to left-side mounting holes on bracket. Make pencil marks on wall through the mounting holes. Holding bracket firmly in place, rotate gauge to left side to permit access to right-side mounting holes. Make pencil marks on wall through the mounting holes. Recommended height is near the eye level of the intended users.
2. At each of the four pencil marks, drill a 3/16” hole approximately 7/8” deep. Use a masonry type bit if drilling through ceramic tile.
3. Gently tap the four screw anchors into the holes until they are flush with the wall.
4. Position the manometer and bracket over the screw holes and screw bracket into wall first on one side, then the other (using the procedure outlined above to gain access to each of the four mounting holes). Take care not to over tighten screws.
5. Attach eight-foot length of coiled tubing to air inlet at bottom of manometer. Wrap cuff around bulb and store in mounting bracket/storage compartment behind gauge.
   Note: If the mounting hardware supplied is not suitable for the application, select hardware of adequate size and type to secure the instrument firmly to the wall.
   Important: The instrument is designed to permit wall mounting without having to first remove the bracket from the instrument. If the instrument is removed from the bracket for mounting or service, we recommend applying removable Loctite to the bracket hardware to prevent the instrument from working loose. Loctite can be obtained from most hardware stores.

Assembly Instructions

1. With base on its side connect upright outer pole to base using the long 6 mm hex screw and washer. Tighten with the large hex key provided. Tighten hardware as securely as possible. (To prevent loosening, periodically check that hardware remains securely tightened.) Reposition base upright. (Figure 1)

2. Slide stainless steel inner pole inside outer pole with open end up. Make sure shock absorbing spring is inside the outer pole and tighten. (Figure 2)

3. Attach metal basket to platform using two 3 mm hex screws. Tighten with small hex key provided.(Figure 3)

4. Attach manometer bracket (with attached manometer) to platform using short 6 mm hex screw and washer. Tighten with large hex key. (Figure 4)

5. Place assembly consisting of manometer, cuff storage basket and platform on top of stainless-steel inner pole, making sure the pole goes completely inside collar. Use tightening device and small hex key as shown.(Figure 5)

6. Connect coiled tubing to gauge inlet. (Note: The coiled tubing may be difficult to connect; moisten with soapy water if necessary.) Refer to booklet titled Diagnostix Aneroid: Pocket, Palm, Clock Type (9350N-00) for instructions on operating the unit.

Schematic Parts List

ABOUT COMPANY

• To register your product visit us at www.adctoday.com/register
• FOR QUESTIONS, COMMENTS, OR SUGGESTIONS CALL TOLL FREE: 1-800-ADC-2670 OR VISIT www.adctoday.com/feedback
• 55 Commerce Drive
• Hauppauge, NY 11788
• Customer Service: 1-800-ADC-2670
• Voice: 1-631-273-9600
• Fax: 1-631-273-9659
• email: info@adctoday.com
• http://www.adctoday.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>