ideal lux Ray PL D60 Ceiling Lamp Installation Guide
- June 15, 2024
- ideal lux
Table of Contents
ideal lux Ray PL D60 Ceiling Lamp
INSTALLATION GUIDE
1. Ray PL D60 Ceiling lamp
LED 44W / 220~240V 50/60Hz
– 8021696327693 BIANCO
– 8021696327686 NERO
2. SAFETY
FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION.
THE LIGHTING FITTING SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS
ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE
REFERENCE.
SAFETY
SAFElY INSTRUCTIONS
1. This fitting is produced and tested in accordance with the strictest European safety standards (EN 60 .598-1).
2. This fitting cannot be disposed of as household waste. For disposal
information ask the local authorities about how to collect it.
3. As indicated by specific regulations, the lighting fitting should be
installed by a qualified electrician.
4. If the external wire is damaged it has to be replaced exclusively by the
manufacturer, distributor or by a qualified electrician.
5. Always isolate power before commencing installation, maintenance or
repair.
6. The luminaire contains certain parts which can be very hot.
7. Each material requires specific mounting accessories. Use screws and wall
plugs suitable for the material to which they are fastened. Those included may
be unsuitable.
8. Always tighten the screws firmly to avoid contact problems.
9. This fitting should only be installed indoors.
10. Luminaires not suitable for recessed on normally flammable surfaces.
11. Luminaire not suitable for direct mounting on normal flammable surfaces.
12. This fitting is only suitable for fixing to the ceiling.
13. This fitting is only suitable for fixing to the wall.
14. The weight of the larnp has to be supported by the chain. Adjust the
length of the electric wire so that it is longer than the chain.
15. Only use lamps which do not exceed the maximum specified wattage.
17. Auto-protected bulb. Only use bulbs marked with this symbol. Halogen
bulbs get very hot. Wait until they cool down before replacing.
18. Cracked or broken safety glass has to be replaced immediately. Use only
manufcturer approved parts complying with regulations.
19. Light source with not-substitutable light emitting diode (LED). Do not
disassemble the product since the diodes can damage the eyes. Do not immerse
in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
20. This tting is equipped with a fuse. If the lamp is out of order, replace
the internal fuse.
21. Class I Electrical safety guaranteed by the main insulation and an
additional protective conductor (earthing) connected with the metal frame of
the lamp. Earthing is obligatory.
22. Class II Electrical safety guaranteed by the main insulation and a double
or reinforced insulation. Earthing not necessary.
23. Class III Electrical safety guaranteed by very low power supply (less
than 50 Volt). Earthing excluded.
24. Not protected.
25. Protected against solid objects greater than 50 mm.
26. Protected against solid objects greater than 12 mm.
27. Protected against solid objects greater than 2,5 mm.
28. Protected against solid objects greater than 1mm.
29. Dust protected.
30. Totally protected against dust inltration.
31. Not protected.
32. Protected against vertically falling water drops.
33. Protected against water drops falling with a maximum angle of 15° to the
vertical axis
34. Protected against rain.
35. Protected against splashing water.
36. Protected against water jets.
37. Protected against strong water jets.
38. Protected against temporary immersion.
39. Protected against prolonged immersion.
40. Luminaire not suitable for covering with th
Specifications
- Brand: IDEAL LUX
- Model: Ray PL D60
- Power: LED 44W
- Voltage: 220-240V
- Frequency: 50/60Hz
- Color Temperature Options: 3000K, 4000K
- Light Source Efficiency Class: D
IDEAL LUX s.r.l.
Via Taglio Destro 32
30035 Mirano (VE) Italy
www.ideal-lux.com
FAQ
Q: Can the light source be replaced by the user?
A: Yes, the light source is replaceable by the end-user. Make sure to use a compatible replacement.
Q: What should I do if the outer electric cable is damaged?
A: If the outer electric cable is damaged, it should be replaced only by the manufacturer, dealer, or a qualified electrician to ensure safety.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>