Vesta Akron VRH-AKRON-30SS Under Cabinet Range Hood User Manual
- June 16, 2024
- VESTA
Table of Contents
Vesta Akron VRH-AKRON-30SS Under Cabinet Range Hood
Warning
- Installation work and electric wiring (including switch location) must be done by the qualified person(s) in accordance with local applicable codes and standards, including fire-rated construction.
- This hood may have sharp edges. Be careful to avoid cuts and abrasions during installation and cleaning.
- The hood must be placed at a minimum distance of 60cm from the cook panel.
- Sufficient air is needed for proper combustion and exhausting of gases through the chimney of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association, and the American Society for Heating, Refrigeration and Air Conditioning Engineer (ASHRAE), and the local code authorities.
- Ducted fans must always be vented to the outdoors.
- This appliance is designed to be operated by adults. Children were not allowed to temper with the controls or play with this appliance.
- WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
- When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
WARNING – TO REDUCE THE RISK OF FIRE, USE ONLY THE METAL DUCTWORK
WARNING – TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP FIRE, OBSERVE THE FOLLOWING
- SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, then turn o ffthe burner, BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
- NEVER PICK UP A FLAMING PAN – You may be burned.
- DO NOT USE WATER, including wet dishcloths or towels – a violent steam explosive will result
- Use an extinguisher ONLY if:
- You know you have a Class ABC extinguisher, and you already know how to operate it;
- The fire is small and contained in the area where it started;
- The fire department is being called;
- You can fight the fire with your back to an exit.
WARNING – TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
- Never leave surface units unattended at high settings. Boil overs cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.
- Always turn hood ON when cooking at high heat or when flambéing food.
- Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
- Use proper pan size. Always use cookware appropriate for the size of the element.
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON, KEEP IN MIND THE FOLLOWING:
- Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
- Before servicing or cleaning unit, switch power o ffat service panel and lock the service disconnecting means to prevent power from being switch on accidently. When service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
Tools Needed
Parts & Accessories
Product Dimension
Dimensions| volts| Hertz| Fan CFM| Speeds| Light
Wattage| Stainless steel grade
---|---|---|---|---|---|---
755mm(29.7”)|
120
|
60
|
850
|
3
|
5Wx1
|
430
560 ( 22 “)
158mm ( 6.2 “)
Installation
Switching to Top Round Vent Adapter
There are 2 perforated circles at the back and top corner. Based on the location of your wires, punch through the circle that is the closest to your wire location. Also apply two rubbers on the back.
Snap on the rubber ring.
Feed the wires through the hole.
Connect round vent to vent adapter. Seal with aluminum foil tape.
Connect the wires:
- Black to Hot line
- White to Neutral line
- Green to Ground line
- Secure with “Twist-on Caps”
Operations
Introduction Of Control Panel
The hood is operated using 3 speeds soft touch control on the front panel.
Setting the speed:
The speed option is easy to set by touching control panel If want low speed
you can touch “-” and “+” is the button to increase the speed.
Setting the light intensity level:
This range hood offers an upgraded illumination mechanism and has two light
intensity levels. By touching the light button, a low intensity is set. If you
touch the button again, higher light intensity is set. By touching the button
third time, the light will turn off.
Setting the timer delay:
While the range hood is running, touch POWER to initiate the time delay.
Maintenance
Exterior Body:
Clean grease with cloth. Apply a small amount of stainless steel solution and
wipe with dry cloth.
Filters:
The grease filters should be cleaned frequently (every two months of
operation, or more frequently for heavy use). You can either clean the filters
by hand with warm detergent solution and then rinse. Or you can use your
dishwasher to do the cleaning. When you remove the filters, please do not bend
them. After cleaning, please dry them before refitting.
Oil Collector:
For the oil collector located inside the product, you can regularly check it
to see if there are excess oil. If it does, you can clean the collector with
warm detergent, rinse it, and let it dry before refitting.
Warranty
TO OBTAIN SERVICE UNDER WARRANTY:
You must present proof of original purchase date. Please provide an original
dated proof of purchase (sales receipt/ invoice) in order to obtain service
under warranty.
Lifetime Motor Warranty
The motor, which is covered by lifetime warranty, should be provided free of
charge by your local reseller given it failed due to manufacturing defects.
Subject to the conditions and limitations set forth below, your local reseller
should, at its option, either repair or replace it with new or refurbished
motor to be functionally equivalent to new. The consumer is responsible for
all shipping costs.
One Year Parts Warranty
For one year from the date of original purchase, your local reseller will
provide free of charge, non-consumable replacement parts or components that
failed due to manufacturing defects. Subject to the conditions and limitations
set forth below, your local reseller will, at its option, either repair or
replace any part of its products that prove defective by reason of improper
workmanship or materials. Repaired parts or replacement products will be
provided by your local reseller on an exchange basis, and will be either new
or refurbished to be functionally equivalent to new. The consumer is
responsible for all shipping costs. Consumable parts not covered by this
warranty include but not limited to: Light bulbs, metal, aluminum and charcoal
filters.
Who is Covered
This warranty is extended to the original purchaser for products purchased for
ordinary home use.
This Warranty Will Be Voided When:
Product damaged through negligence, improper installation, accident, abuse,
misuse, natural disaster, insufficient or excessive electrical supply,
abnormal mechanical or environmental conditions, or any unauthorized
disassembly, repair, modification, or failure to follow installation
instructions. When product is used commercially or other than its intended
purpose. Damaged because of improper connection with equipment of other
manufacturers. Repaired or modified by anyone other than your local reseller’s
authorized agents. This limited warranty also does not apply to any product on
which the original identification information has been altered, obliterated or
removed, has not been handled or packaged correctly or has been sold as
second-hand.
What is Not Covered:
Consumable parts such as light bulbs, metal and charcoal filters. The natural
wear of finish, and wear due to improper maintenance, use of corrosive and
abrasive cleaning products, pads, and oven cleaner products. Chips, dents or
cracks due to abuse, misuse, freight damage, or improper installation. Damage
of product caused by accident, fire, floods or act of God. The manufacturer
and/or distributor/reseller is not liable for, and does not cover under
warranty, any loss of properties or any costs associated with removing,
servicing, installing, or determining the source of problems with this
product. This warranty is valid in the country of the original purchase at
retail. It is non-transferable and applies only to the original purchaser and
does not extend to subsequent owners of this product. Any applicable implied
warranties, including the warranty of merchantability, are limited in duration
to a period of express warranty as provided herein beginning with the date of
original purchase at retail and, no warranties, whether express or implied,
shall apply to this product thereafter.
To obtain warranty service, you may contact your local reseller from which you purchased this product. Please confirm the terms of your local reseller’s policies prior to contacting. Typically, you must include product identification information, including model number and serial number with a detailed description of the problem you are experiencing. You must also include proof of the date of original retail purchase as evidence that the product is within the applicable warranty period.
Specifications
- Body Stainless Steel
- Power Rating 120V/60Hz (USA & Canada standard)
- General Input Power 200W + 5W of Light x Voltage of Light
- Motor Input Power 200 W
- Motor Revolution 1200 RPM (±10%) to 1500 RPM (±10%)
- Levels Of Speed Control 3
- Maximum Airflow 850 CFM
- Air Pressure 400 Pa (450 Pa Maximum)
- Noise Level (dB)
- Approximately 52 to 72 (Lowest to highest Speed)
- Motor Type Single Chamber Ultra Quiet
- Fan Type Pivoted / Sirocco
- Control Type Electronic Touch Control
- Filtration Type Baffle Filter
- Illumination LED light 5Wx1
- Venting Size Top, 6 inches Round
- Interference Protection Radio Frequency Interference Protected.
Disclaimer
Carefully inspect all items for damages before accepting delivery. Note any damages on the freight bill or express receipt. Request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately. Failure to do so may result in the denial of your claim. The carrier will furnish you with necessary forms for filing a claim.
Damages caused during transit are not covered under our warranty. Please contact us to file an insurance claim. Please inspect contents of package(s) carefully upon receiving! We must be notified of any damages and/or missing parts within five (5) days upon your receipt of package(s). Claims will not be accepted after five (5) days. NOTE: Items were thoroughly tested and carefully packed in our factory before shipping.
Products must be returned in good working condition with ALL original parts and documentation packed in ALL original cartons, fillers and shipping cartons. A restocking fee of 15% will be charged for all approved return(s). Exchanges or returns may not be accepted if any packaging is missing.
Make sure to inspect the hood for damages and defects before installation. Appearance flaws of the hood found after installation and not affecting hood performance is not covered under our warranty for returns or exchanges. Service visits not covered under warranty will carry a service charge.
Before Installation: Return for exchange or refund (please see above for acceptable returns). After Installation: NO exchange or refund.
Contact Us
Dear Valued Customer,
Thank you for choosing Vesta as your preferred provider for kitchen
appliances. We are committed to providing you with exceptional customer
service and support. If you require assistance with any of our products,
please do not hesitate to contact us.You can reach our customer service team
by choosing one of the methods below and one of our representatives will
respond to you promptly. Thank you for your business, and we look forward to
serving you soon.
Phone:
905-886-5858
9:30am-5:00pm (Eastern Time), Monday to Friday, except holidays
Email:service@vesta.kitchen
Online form:
https://www.vesta.kitchen/service
Sincerely,
The Vesta Service Team
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>