Dongguan Hengyin Electronic Technology Co Ltd HY-5512 Multiple Function RGB Light Bluetooth Speaker Instruction Manual

Dongguan Hengyin Electronic Technology Co Ltd HY-5512 Multiple Function

RGB Light Bluetooth Speaker

Component

• Bluetooth Speaker x 1
• Charging Cable x 1
• Microphone x 1 (Optional)

Specification

• Bluetooth: V5.0, Transmission Ranges10 Meter
• Input: DC 5V, Output: RMS 10W
• Speaker: 30 10W 4″x2
• Battery Capacity:2400mAh
• FM Frequency range: 87.5-108MHz, Build-in antenna
• Music Mode: Support MMP3play,
• Maximum capacity Support≤32G

Key Manual

1. ON /OFF
2. LED MODES
3. PREVIOUS SONG / VOL-
4. PLAY / PAUSE / SCAN
5. NEXT SONG / VOL+
6. SPEAKER MODE
7. CHARGING INDICATOR
8. MIC INPUT
9. AUX INPUT
10. USB PORT
11. TF CARD
12. DC 5V CHARGING PORT

Bluetooth Function

1. Turn on the power switch or press the key repeatedly into Bluetooth Mode.
2. Turn on the Bluetooth connection in your phone and search for the Bluetooth name “BT SPEAKER”, Click to connect.
3. Once connected, you can play music in the Music application on your phone.
   PS: Please make sure your phone volume is turned on and turn up the volume of your phone to a suitable range.

TWS Function

1. Turn on another type of bluetooth speaker and keep both of them in Bluetooth Function.
2. press and hold the key of one of the speakers and don’t release it until you hear the bell ring.
3. Wait for a moment. The speaker will connect to another speaker automatically.
   PS: If another speaker was connected to the same phone before, you should disconnect it on the phone first.

Music Mode

1. Put in a Micro SD card or USB flash disk or press the key repeatedly into music mode for playing MP3 music on a Micro SD card or USB flash disk.
2. Press the CD key can play/pause music. Press the key can switch songs press and hold the the key can turn up/down the volume of the speaker.

FM Radio

1. Turn on the speaker and press the key repeatedly into FM Radio Mode.
2. Press and hold the CD key for a second the speaker will search and store the broadcast channel automatically. Once the search is finished, you can press the key to switch the broadcast channel.
   PS: The speaker should close to the window or balcony and stay away from interference like fluorescent lame, computer, motor and so on, which may improve the listening effect in FM Radio.

AUX Input

1. Use a suitable audio cable to connect audio output equipment. Turn on the equipment and play music at a suitable volume.
2. Put the audio cable into the Input port of the speaker and you can press the key repeatedly to switch into Aux Input Mode.
3. press the key can play or pause, press and hold the key can turn up/down the volume.

MIC Port

Put the Wired Microphone into the MIC Port, Turn on the Microphone then you can use
PS: In FM Mode, You can not use the Microphone Function, Please switch to other modes, also, Do not head to the woofer, otherwise there will be noise. Please turn off the microphone when you do not use it.

LED Light Function
Press the key repeatedly to switch the LED Light Mode. Press the key and hold for a second can turn on/off the LED light function.
PS: The machine may turn off the LED light automatically in the FM radio function to decrease interference for a better listening effect.

FCC Warning

This des device may not cause a mith to infer rules and (2) his device must cop interventions: received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection and correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>